Re: [PATCH 3/3] sched: Use cpu_dying() to fix balance_push vs hotplug-rollback

[Vincent Donnefort]

On Mon, Apr 19, 2021 at 11:56:30AM +0100, Vincent Donnefort wrote:
> On Thu, Apr 15, 2021 at 03:32:11PM +0100, Valentin Schneider wrote:
> > On 15/04/21 10:59, Peter Zijlstra wrote:
> > > Can't make sense of what I did.. I've removed that hunk. Patch now looks
> > > like this.
> > >
> > 
> > Small nit below, but regardless feel free to apply to the whole lot:
> > Reviewed-by: Valentin Schneider <valentin.schneider@xxxxxxx>
> > 
> > @VincentD, ISTR you had tested the initial version of this with your fancy
> > shmancy hotplug rollback stresser. Feel like doing this
> 
> I indeed wrote a test to verify all the rollback cases, up and down.
> 
> It seems I encounter an intermitent issue while running several iterations of
> that test ... but I need more time to debug and figure-out where it is blocking.

Found the issue:

$ cat hotplug/states:
219: sched:active
220: online

CPU0: 

$ echo 219 > hotplug/fail
$ echo 0 > online

=> cpu_active = 1 cpu_dying = 1

which means that later on, for another CPU hotunplug, in
__balance_push_cpu_stop(), the fallback rq for a kthread can select that
CPU0, but __migrate_task() would fail and we end-up in an infinite loop,
trying to migrate that task to CPU0.

The problem is that for a failure in sched:active, as "online" has no callback,
there will be no call to cpuhp_invoke_callback(). Hence, the cpu_dying bit would
not be reset.

Maybe cpuhp_reset_state() and cpuhp_set_state() would then be a better place to
switch the dying bit?

> 
> > 
> > > So instead, make sure balance_push is enabled between
> > > sched_cpu_deactivate() and sched_cpu_activate() (eg. when
> > > !cpu_active()), and gate it's utility with cpu_dying().
> > 
> > I'd word that "is enabled below sched_cpu_activate()", since
> > sched_cpu_deactivate() is now out of the picture.
> > 
> > [...]
> > > @@ -7639,6 +7639,9 @@ static DEFINE_PER_CPU(struct cpu_stop_wo
> > >
> > >  /*
> > >   * Ensure we only run per-cpu kthreads once the CPU goes !active.
> > > + *
> > > + * This is active/set between sched_cpu_deactivate() / sched_cpu_activate().
> > 
> > Ditto
> > 
> > > + * But only effective when the hotplug motion is down.
> > >   */
> > >  static void balance_push(struct rq *rq)
> > >  {