Re: [RFC PATCH net-next v3 13/20] net: dsa: qca8k: make rgmii delay configurable

[Vladimir Oltean]

On Wed, May 05, 2021 at 12:29:07AM +0200, Ansuel Smith wrote:
> The legacy qsdk code used a different delay instead of the max value.
> Qsdk use 1 ps for rx and 2 ps for tx. Make these values configurable
> using the standard rx/tx-internal-delay-ps ethernet binding and apply
> qsdk values by default. The connected gmac doesn't add any delay so no
> additional delay is added to tx/rx.
> 
> Signed-off-by: Ansuel Smith <ansuelsmth@xxxxxxxxx>
> ---
>  drivers/net/dsa/qca8k.c | 51 +++++++++++++++++++++++++++++++++++++++--
>  drivers/net/dsa/qca8k.h | 11 +++++----
>  2 files changed, 55 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
> index 22334d416f53..cb9b44769e92 100644
> --- a/drivers/net/dsa/qca8k.c
> +++ b/drivers/net/dsa/qca8k.c
> @@ -779,6 +779,47 @@ qca8k_setup_mdio_bus(struct qca8k_priv *priv)
>  	return 0;
>  }
>  
> +static int
> +qca8k_setup_of_rgmii_delay(struct qca8k_priv *priv)
> +{
> +	struct device_node *ports, *port;
> +	u32 val;
> +
> +	ports = of_get_child_by_name(priv->dev->of_node, "ports");

Consider falling back to searching for the "ethernet-ports" name too,
DSA should now support both.

> +	if (!ports)
> +		return -EINVAL;
> +
> +	/* Assume only one port with rgmii-id mode */
> +	for_each_available_child_of_node(ports, port) {
> +		if (!of_property_match_string(port, "phy-mode", "rgmii-id"))
> +			continue;
> +
> +		if (of_property_read_u32(port, "rx-internal-delay-ps", &val))
> +			val = 2;
> +
> +		if (val > QCA8K_MAX_DELAY) {
> +			dev_err(priv->dev, "rgmii rx delay is limited to more than 3ps, setting to the max value");
> +			priv->rgmii_rx_delay = 3;

?!
3 picoseconds is not a lot of clock skew for a 125/25/2.5 MHz clock. 3 nanoseconds maybe?

> +		} else {
> +			priv->rgmii_rx_delay = val;
> +		}
> +
> +		if (of_property_read_u32(port, "rx-internal-delay-ps", &val))
> +			val = 1;
> +
> +		if (val > QCA8K_MAX_DELAY) {
> +			dev_err(priv->dev, "rgmii tx delay is limited to more than 3ps, setting to the max value");
> +			priv->rgmii_tx_delay = 3;
> +		} else {
> +			priv->rgmii_rx_delay = val;
> +		}
> +	}
> +
> +	of_node_put(ports);
> +
> +	return 0;
> +}
> +
>  static int
>  qca8k_setup(struct dsa_switch *ds)
>  {
> @@ -808,6 +849,10 @@ qca8k_setup(struct dsa_switch *ds)
>  	if (ret)
>  		return ret;
>  
> +	ret = qca8k_setup_of_rgmii_delay(priv);
> +	if (ret)
> +		return ret;
> +
>  	/* Enable CPU Port */
>  	ret = qca8k_reg_set(priv, QCA8K_REG_GLOBAL_FW_CTRL0,
>  			    QCA8K_GLOBAL_FW_CTRL0_CPU_PORT_EN);
> @@ -1018,8 +1063,10 @@ qca8k_phylink_mac_config(struct dsa_switch *ds, int port, unsigned int mode,
>  		 */
>  		qca8k_write(priv, reg,
>  			    QCA8K_PORT_PAD_RGMII_EN |
> -			    QCA8K_PORT_PAD_RGMII_TX_DELAY(QCA8K_MAX_DELAY) |
> -			    QCA8K_PORT_PAD_RGMII_RX_DELAY(QCA8K_MAX_DELAY));
> +			    QCA8K_PORT_PAD_RGMII_TX_DELAY(priv->rgmii_tx_delay) |
> +			    QCA8K_PORT_PAD_RGMII_RX_DELAY(priv->rgmii_rx_delay) |
> +			    QCA8K_PORT_PAD_RGMII_TX_DELAY_EN |
> +			    QCA8K_PORT_PAD_RGMII_RX_DELAY_EN);
>  		/* QCA8337 requires to set rgmii rx delay */
>  		if (data->id == QCA8K_ID_QCA8337)
>  			qca8k_write(priv, QCA8K_REG_PORT5_PAD_CTRL,
> diff --git a/drivers/net/dsa/qca8k.h b/drivers/net/dsa/qca8k.h
> index 0b503f78bf92..80830bb42736 100644
> --- a/drivers/net/dsa/qca8k.h
> +++ b/drivers/net/dsa/qca8k.h
> @@ -36,12 +36,11 @@
>  #define QCA8K_REG_PORT5_PAD_CTRL			0x008
>  #define QCA8K_REG_PORT6_PAD_CTRL			0x00c
>  #define   QCA8K_PORT_PAD_RGMII_EN			BIT(26)
> -#define   QCA8K_PORT_PAD_RGMII_TX_DELAY(x)		\
> -						((0x8 + (x & 0x3)) << 22)
> -#define   QCA8K_PORT_PAD_RGMII_RX_DELAY(x)		\
> -						((0x10 + (x & 0x3)) << 20)
> -#define   QCA8K_MAX_DELAY				3
> +#define   QCA8K_PORT_PAD_RGMII_TX_DELAY(x)		((x) << 22)
> +#define   QCA8K_PORT_PAD_RGMII_RX_DELAY(x)		((x) << 20)
> +#define	  QCA8K_PORT_PAD_RGMII_TX_DELAY_EN		BIT(25)
>  #define   QCA8K_PORT_PAD_RGMII_RX_DELAY_EN		BIT(24)
> +#define   QCA8K_MAX_DELAY				3
>  #define   QCA8K_PORT_PAD_SGMII_EN			BIT(7)
>  #define QCA8K_REG_PWS					0x010
>  #define   QCA8K_PWS_SERDES_AEN_DIS			BIT(7)
> @@ -251,6 +250,8 @@ struct qca8k_match_data {
>  
>  struct qca8k_priv {
>  	u8 switch_revision;
> +	u8 rgmii_tx_delay;
> +	u8 rgmii_rx_delay;
>  	struct regmap *regmap;
>  	struct mii_bus *bus;
>  	struct ar8xxx_port_status port_sts[QCA8K_NUM_PORTS];
> -- 
> 2.30.2
>