[PATCH 05/17] media: camss: csid-170: don't enable unused irqs

[Jonathan Marek]

csid_isr() only checks for the reset irq, so enabling any other irqs
doesn't make sense. The "RDI irq" comment is also wrong, the register
should be CSID_CSI2_RDIN_IRQ_MASK. Without this fix there may be an
excessive amount of irqs.

Fixes: eebe6d00e9bf ("media: camss: Add support for CSID hardware version Titan 170")
Signed-off-by: Jonathan Marek <jonathan@xxxxxxxx>
---
 drivers/media/platform/qcom/camss/camss-csid-170.c | 6 ------
 1 file changed, 6 deletions(-)

diff --git a/drivers/media/platform/qcom/camss/camss-csid-170.c b/drivers/media/platform/qcom/camss/camss-csid-170.c
index a81cc94c075f..2bc695819919 100644
--- a/drivers/media/platform/qcom/camss/camss-csid-170.c
+++ b/drivers/media/platform/qcom/camss/camss-csid-170.c
@@ -443,12 +443,6 @@ static void csid_configure_stream(struct csid_device *csid, u8 enable)
 	val |= 1 << CSI2_RX_CFG1_MISR_EN;
 	writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1); // csi2_vc_mode_shift_val ?
 
-	/* error irqs start at BIT(11) */
-	writel_relaxed(~0u, csid->base + CSID_CSI2_RX_IRQ_MASK);
-
-	/* RDI irq */
-	writel_relaxed(~0u, csid->base + CSID_TOP_IRQ_MASK);
-
 	val = 1 << RDI_CTRL_HALT_CMD;
 	writel_relaxed(val, csid->base + CSID_RDI_CTRL(0));
 }
-- 
2.26.1