Re: [tip: sched/core] sched/core: Initialize the idle task with preemption disabled

[Alexey Kardashevskiy]

On 08/07/2021 00:14, Guenter Roeck wrote:
> On 7/7/21 5:11 AM, Valentin Schneider wrote:
> > On 07/07/21 14:03, Frederic Weisbecker wrote:
> > > On Wed, Jul 07, 2021 at 12:55:20AM +0100, Valentin Schneider wrote:
> > > > Thanks for the report.
> > > >
> > > > So somehow the init task ends up with a non-zero preempt_count()? Per
> > > > FORK_PREEMPT_COUNT we should exit __ret_from_fork() with a zero 
> > > > count, are
> > > > you hitting the WARN_ONCE() in finish_task_switch()?
> > > >
> > > > Does CONFIG_DEBUG_PREEMPT=y yield anything interesting?
> > > >
> > > > I can't make sense of this right now, but it's a bit late :) I'll 
> > > > grab some
> > > > toolchain+qemu tomorrow and go poke at it (and while at it I need to 
> > > > do the
> > > > same with powerpc).
> > >
> > > One possible issue is that s390's init_idle_preempt_count() doesn't 
> > > apply on the
> > > target idle task but on the _current_ CPU. And since smp_init() ->
> > > idle_threads_init() is actually called remotely, we are overwriting 
> > > the current
> > > CPU preempt_count() instead of the target one.
> >
> > Indeed, this becomes quite obvious when tracing the preemption count
> > changes. This also means that s390 relied on the idle_thread_get() 
> > from the
> > hotplug machinery to properly setup the preempt count, rather than
> > init_idle_preempt_count() - which is quite yuck.
> >
> > I'll write a patch for that and likely one for powerpc.
>
> Can you reproduce the problem with a powerpc qemu emulation ?
> If so, how do you reproduce it there ? Reason for asking is that I don't 
> see
> the problem with any of my powerpc emulations, and I would like to add test
> case(s) if possible.

I can reproduce the problem on powerpc easily - qemu with "-smp 2" does it.


--
Alexey