Re: [PATCH V2 1/3] firmware: zynqmp: Add MMIO read and write support for PS_MODE pin

[Linus Walleij]

On Thu, Aug 5, 2021 at 7:42 PM Piyush Mehta <piyush.mehta@xxxxxxxxxx> wrote:

> Add Xilinx ZynqMP firmware MMIO APIs support to set and get PS_MODE
> pins value and status. These APIs create an interface path between
> mode pin controller driver and low-level API to access GPIO pins.
>
> Signed-off-by: Piyush Mehta <piyush.mehta@xxxxxxxxxx>
> ---
> Changes in v2:
> - Added Xilinx ZynqMP firmware MMIO API support to set and get pin
>   value and status.

I doubt this is "GPIO".
General Purpose? I think not. It seems to be about boot mode.

If you need a userspace ABI, then add sysfs files to this firmware
driver instead of bridging it to the GPIO subsystem.

However I can be argued down from usecases etc that it is used as
GPIO but I need to push back on this.

Yours,
Linus Walleij