Re: [PATCH 0/2] rtc: pch-rtc: add Intel Series PCH built-in read-only RTC

From: Alexandre Belloni
Date: Tue Aug 17 2021 - 16:05:49 EST


On 17/08/2021 18:04:09+0000, Milton Miller II wrote:
>
> On Aug 16, 2021, Alexandre Belloni wrote:
> >On 15/08/2021 01:42:15+0300, Paul Fertser wrote:
> >> On Tue, Aug 10, 2021 at 06:44:34PM +0300, Ivan Mikhaylov wrote:
> >> > Add RTC driver with dt binding tree document. Also this driver
> >adds one sysfs
> >> > attribute for host power control which I think is odd for RTC
> >driver.
> >> > Need I cut it off and use I2C_SLAVE_FORCE? I2C_SLAVE_FORCE is not
> >good
> >> > way too from my point of view. Is there any better approach?
> >>
> >> Reading the C620 datasheet I see this interface also allows other
> >> commands (wake up, watchdog feeding, reboot etc.) and reading
> >statuses
> >> (e.g Intruder Detect, POWER_OK_BAD).
> >>
> >> I think if there's any plan to use anything other but RTC via this
> >> interface then the driver should be registered as an MFD.
> >>
> >
> >This is not the current thinking, if everything is integrated, then
> >there is no issue registering a watchdog from the RTC driver. I'll
> >let
> >you check with Lee...
>
> I think the current statement is "if they are truly disjoint
> hardware controls" then an MFD might suffice, but if they require
> software cordination the new auxillary bus seems to be desired.
>

Honestly, the auxiliary bus doesn't provide anything that you can't do
by registering a device in multiple subsystem from a single driver.
(Lee Jones, Mark Brown and I did complain at the time that this was yet
another back channel for misuses).

> >>However, I'm not sure what is the correct interface for
> >poweroff/reboot
> >control.
>
> While there is a gpio interface to a simple regulator switch,
> the project to date has been asserting direct or indirect
> gpios etc to control the host. If these are events to
> trigger a change in state and not a direct state change
> that some controller trys to follow, maybe a message delivery
> model? (this is not to reboot or cycle the bmc).
>
> milton

--
Alexandre Belloni, co-owner and COO, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com