Re: [PATCH V3 3/3] gpio: modepin: Add driver support for modepin GPIO controller

[Bartosz Golaszewski]

On Wed, Aug 18, 2021 at 10:11 AM Piyush Mehta <piyush.mehta@xxxxxxxxxx> wrote:
>
> This patch adds driver support for the zynqmp modepin GPIO controller.
> GPIO modepin driver set and get the value and status of the PS_MODE pin,
> based on device-tree pin configuration. These four mode pins are
> configurable as input/output. The mode pin has a control register, which
> have lower four-bits [0:3] are configurable as input/output, next four-bits
> can be used for reading the data  as input[4:7], and next setting the
> output pin state output[8:11].
>
> Signed-off-by: Piyush Mehta <piyush.mehta@xxxxxxxxxx>
> Acked-by: Michal Simek <michal.simek@xxxxxxxxxx>
> Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
> ---

Which tree should this go through?

Bart