[PATCH 12/22] PCI: rcar: Use SET_PCI_ERROR_RESPONSE() when device not found

[Naveen Naidu]

An MMIO read from a PCI device that doesn't exist or doesn't respond
causes a PCI error.  There's no real data to return to satisfy the
CPU read, so most hardware fabricates ~0 data.

Use SET_PCI_ERROR_RESPONSE() to set the error response, when a faulty
read occurs.

This helps unify PCI error response checking and make error check
consistent and easier to find.

Compile tested only.

Signed-off-by: Naveen Naidu <naveennaidu479@xxxxxxxxx>
---
 drivers/pci/controller/pcie-rcar-host.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pci/controller/pcie-rcar-host.c b/drivers/pci/controller/pcie-rcar-host.c
index 8f3131844e77..80dbc6f717d6 100644
--- a/drivers/pci/controller/pcie-rcar-host.c
+++ b/drivers/pci/controller/pcie-rcar-host.c
@@ -162,7 +162,7 @@ static int rcar_pcie_read_conf(struct pci_bus *bus, unsigned int devfn,
 	ret = rcar_pcie_config_access(host, RCAR_PCI_ACCESS_READ,
 				      bus, devfn, where, val);
 	if (ret != PCIBIOS_SUCCESSFUL) {
-		*val = 0xffffffff;
+		SET_PCI_ERROR_RESPONSE(val);
 		return ret;
 	}
 
-- 
2.25.1