Hi,
[removed previous conversation]
Hi Dmitry and Abhinav,
Just wanted to follow up on this thread. I've gone over the MSM-specific
DSC params for DP and DSI and have found a few shared calculations and
variables between both DSI and DP paths:
- (as mentioned earlier in the thread) almost all the calculations in
dpu_dsc_populate_dsc_config() match dsi_populate_dsc_params() [1]. The
only difference in the math I'm seeing is initial_scale_value.
The value in dsi code is valid for initial_offset = 6144. Please use
the formula from the standard (= sde_dsc_populate_dsc_config) and add
it to drm_dsc_helper.c
If I remember correctly the last remaining item in
dsi_populate_dsc_params() (except mentioned initial_offset) was
line_buf_depth, see [3]. I'm not sure about setting it to bpc+1.
According to the standard it should come from a DSC decoder spec,
which means it should be set by the DSI panel driver or via
drm_dp_dsc_sink_line_buf_depth() in the case of DP output.
- dsc_extra_pclk_cycle_cnt and dce_bytes_per_line, which were introduced
in Kuogee's v1 DSC series [2], are used for DSI, DP, and the DPU timing
engine. dsc_extra_pclk_cycle_cnt is calculated based on pclk_per_line
(which is calculated differently between DP and DSI), but
dce_bytes_per_line is calculated the same way between DP and DSI.
To avoid having to duplicate math in 2 different places, I think it
would help to have these calculations in some msm_dsc_helper.c file. Any
thoughts on this?
dsc_extra_pclk_cycle_cnt and dce_bytes_per_line are used only in DPU
code, so they can stay in DPU driver.
Thanks,
Jessica Zhang
[1]
https://elixir.bootlin.com/linux/v6.3-rc2/source/drivers/gpu/drm/msm/dsi/dsi_host.c#L1756
[2] https://patchwork.freedesktop.org/patch/519845/?series=113240&rev=1
[3] https://patchwork.freedesktop.org/patch/525441/?series=114472&rev=2