Re: [PATCH v2 9/9] ARM: dts: chameleonv3: Add video device nodes

[Krzysztof Kozlowski]

On 26/02/2024 12:09, Paweł Anikiel wrote:
> On Mon, Feb 26, 2024 at 10:15 AM Krzysztof Kozlowski
> <krzysztof.kozlowski@xxxxxxxxxx> wrote:
>>
>> On 21/02/2024 17:02, Paweł Anikiel wrote:
>>> Add device nodes for the video system present on the Chameleon v3.
>>> It consists of six framebuffers and two Intel Displayport receivers.
>>>
>>> Signed-off-by: Paweł Anikiel <panikiel@xxxxxxxxxx>
>>> ---
>>
>> ...
>>
>>> +             dprx_sst: dp-receiver@c0064000 {
>>> +                     compatible = "intel,dprx-20.0.1";
>>> +                     reg = <0xc0064000 0x800>;
>>> +                     interrupt-parent = <&dprx_sst_irq>;
>>> +                     interrupts = <0 IRQ_TYPE_EDGE_RISING>;
>>> +                     intel,max-link-rate = <0x1e>;
>>
>> Rate is not in hex! Rate is in Hz, at least usually...
>>
>> Fix your bindings...
> 
> This is the DisplayPort link rate, for which the allowed values are
> 8.1 Gbps, 5.4 Gbps, 2.7 Gbps, or 1.62 Gbps. The standard way to encode
> them (used in the DisplayPort DPCD registers and this device's

Then it is in bps or some other units:

https://github.com/devicetree-org/dt-schema/blob/main/dtschema/schemas/property-units.yaml

> configuration) is by multiples of 0.27Gbps. This value (AFAIK) is
> usually represented in hex, so 8.1Gbps would be 0x1e.

No, the value is represented in logical units. Frequency in Hz. Rate in
bps/kbps/etc. Voltage in volts.

Best regards,
Krzysztof