Re: [PATCH] Bluetooth: qca: generalise device address check

[Johan Hovold]

On Tue, Apr 30, 2024 at 06:22:26PM +0530, Janaki Ramaiah Thota wrote:
> On 4/30/2024 12:37 PM, Johan Hovold wrote:
> > On Mon, Apr 29, 2024 at 01:31:53PM -0400, Luiz Augusto von Dentz wrote:

> >> Anyway the fact that firmware loading itself is programming a
> >> potentially duplicated address already seems wrong enough to me,
> >> either it shall leave it as 00... or set a valid address otherwise we
> >> always risk missing yet another duplicate address being introduced and
> >> then used over the air causing all sorts of problems for users.
> >>
> >> So to be clear, QCA firmware shall never attempt to flash anything
> >> other than 00:00:00:00:00:00 if you don't have a valid and unique
> >> identity address, so we can get rid of this table altogether.
> > 
> 
> Yes agree with this point.
> BD address should be treated as invalid if it is 00:00:00:00:00:00.

We all agree on that.

> NVM Tag 2: bd address is default BD address (other than 0), should be
> configured as valid address and as its not unique address and it will
> be same for all devices so mark it is configured but still allow
> user-space to change the address.

But here we disagree. A non-unique address is not a valid one as it will
cause collisions if you have more than one such controller.

I understand that this may be convenient/good enough for developers in
some cases, but this can hurt end users that do not realise why things
break.

And a developer can always configure an address manually or patch the
driver as needed for internal use.

Are there any other reasons that makes you want to keep the option to
configure the device address through NVM files? I'm assuming you're not
relying on patching NVM files to provision device-specific addresses
after installation on target?

Johan