2.0.35 UP stock, no modules, 2.7.2.1, epic100 eth running at 10mbit,
64mb ECC ram with 128mb swap, PII-333 Asus P2L97S with built-in
Adaptec SCSI:
(scsi0) <Adaptec AIC-7880 Ultra SCSI host adapter> found at PCI 6/0
(scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs
(scsi0) BIOS enabled, IO Port 0xd000, IRQ 12
(scsi0) IO Memory at 0xe3000000, MMAP Memory at 0x4805000
(scsi0) Resetting channel
(scsi0) Downloading sequencer code... 406 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI)
5.0.19/3.2.4
<Adaptec AIC-7880 Ultra SCSI host adapter>
scsi : 1 host.
(scsi0:0:-1:-1) Scanning channel for devices.
Vendor: WDIGTL Model: ENTERPRISE Rev: 1.91
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
scsi : detected 1 SCSI disk total.
(scsi0:0:0:0) Using wide (16 bit) transfers.
(scsi0:0:0:0) Synchronous at 10.0MHz, offset 8.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 8515173 [4157 MB]
[4.2 GB]
Machine is a webserver. "free" shows
% free
total used free shared buffers cached
Mem: 63352 61852 1500 16372 9316
-/+ buffers: 52536 4186488
Swap: 128516 1376 127140 39696
No noticeable problems, nothing else in the logs.
Thanks for reading this far ;),
-- Pete Harlan harlan@pointofchoice.com- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.altern.org/andrebalsa/doc/lkml-faq.html