I just compiled and installed 2.0.36 on my production-server. But to no
extend: I get massive, reproducable lockups (while it was working fine
under 2.0.34).
What works after a lockup:
* <ALT>-<Fn> console switching
* Numlock, capslock
* The machine responds to ping's
What doesn't work:
* Any other keyboard-input
* Telnet, http etc
Syslog shows (both times):
Nov 18 13:10:12 ttewww in.smtpd[2129]: connect from nic.funet.fi
Nov 18 13:10:15 ttewww innd: ttewww.tte.ele.tue.nl connected 15 streaming
allowed
Nov 18 13:10:15 ttewww innd: ttewww.tte.ele.tue.nl:15 closed seconds 0
accepted 0 refused 0 rejected 0
Attached is the dmesg-output for the .36 kernel.
If really needed, I can give someone (Alan?) telnet-access to the
computer. I can supply any informating needed to debug this thing.
(My suspect is the 3c509)
Greetings,
Arjan van de Ven
Memory: sized by int13 088h
Console: 16 point font, 400 scans
Console: colour VGA+ 80x25, 1 virtual console (max 63)
Calibrating delay loop.. ok - 33.18 BogoMIPS
Memory: 18892k/20480k available (660k kernel code, 384k reserved, 544k data)
This processor honours the WP bit even when in supervisor mode. Good.
Swansea University Computer Society NET3.035 for Linux 2.0
NET3: Unix domain sockets 0.13 for Linux NET3.035.
Swansea University Computer Society TCP/IP for NET3.034
IP Protocols: IGMP, ICMP, UDP, TCP, IPIP
Linux IP multicast router 0.07.
VFS: Diskquotas version dquot_5.6.0 initialized
Checking 386/387 coupling... Ok, fpu using exception 16 error reporting.
Checking 'hlt' instruction... Ok.
Linux version 2.0.36 (root@ttewww) (gcc version 2.7.2.3) #8 Wed Nov 18 12:10:11 CET 1998
Starting kswapd v 1.4.2.2
Serial driver version 4.13 with no serial options enabled
tty00 at 0x03f8 (irq = 4) is a 16450
tty01 at 0x02f8 (irq = 3) is a 16450
hda: WDC AC2540H, 515MB w/128kB Cache, CHS=1048/16/63
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Floppy drive(s): fd0 is 1.44M, fd1 is 1.2M
FDC 0 is an 8272A
scsi : 0 hosts.
scsi : detected total.
tunnel: version v0.2b2
eth0: 3c509 at 0x300 tag 1, BNC port, address 00 20 af 39 7b 6f, IRQ 10.
3c509.c:1.16 2/3/98 becker@cesdis.gsfc.nasa.gov
Partition check:
hda: hda1 hda2
VFS: Mounted root (ext2 filesystem) readonly.
Adding Swap: 56948k swap-space (priority -1)
eth0: Setting Rx mode to 1 addresses.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/