Re: 2.0.36 serial.o module count wrong

Peter T. Breuer (ptb@it.uc3m.es)
Wed, 3 Feb 1999 15:30:25 +0100 (MET)

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Matthew Wilcox: "Re: linux capabilities and ACLs"
Previous message: Monty: "Kernel interface changes (was Re: cdrecord problems on recent Linux versions)"
In reply to: Mike A. Harris: "Re: k6 freeze in kernel 2.0.36"

"A month of sundays ago Peter T. Breuer wrote:"
>
> On 2.0.36 the serial.o use count goes to 2 at load (via insmod) and
> stays there. Running X increments it to 3 ..

Wups - looks like it does the same on 2.0.25 too. It must be that
setserial increments the count at boot, then blocks, then goes wahwah.

It's not running, but it reports device busy ... *silly VX board*.
There's no process holding the ports open. Not X nor gpm.

Peter

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

Next message: Matthew Wilcox: "Re: linux capabilities and ACLs"
Previous message: Monty: "Kernel interface changes (was Re: cdrecord problems on recent Linux versions)"
In reply to: Mike A. Harris: "Re: k6 freeze in kernel 2.0.36"