i have a problem getting linux to see what appears to be an onboard
Intel EtherExpress Pro 10/100 on a Digital Prioris XL 6200 server,
(PentiumPRO 200),
It appears to see the card but apparently it doesnt assign an IRQ.
The kernel i used is vanilla 2.2.13, the driver is not
compiled as a module.
I tried getting a "testing" driver from
ftp://cesdis.gsfc.nasa.gov/linux/drivers/testing
but the result are worse ( the kernel hangs on boot)
what can i do ?
(apart from getting another card =)
enrico
this is what it gives me at boot :
sktr.c: v1.01 08/29/97 by Christoph Goos
Found Intel i82557 PCI Speedo at I/O 0x5800, IRQ 0.
The PCI BIOS has not enabled this device! Updating PCI command 0001->0005.
PCI latency timer (CFLT) is 0x42.
eepro100.c:v1.06 10/16/98 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
eth0: Intel EtherExpress Pro 10/100 at 0x5800, 00:A0:C9:60:20:84, IRQ 0.
Board assembly 645520-034, Physical connectors present: RJ45
Primary interface chip DP83840 PHY #1.
DP83840 specific setup, setting register 23 to 8462.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0x49caa8d6).
Receiver lock-up workaround activated.
eepro100.c:v1.06 10/16/98 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
Output of /proc/pci :
PCI devices found:
Bus 0, device 0, function 0:
Host bridge: Intel 82441FX Natoma (rev 2).
Medium devsel. Fast back-to-back capable. Master Capable. Latency=64.
Bus 0, device 10, function 0:
Ethernet controller: Intel 82557 (rev 2).
Medium devsel. Fast back-to-back capable. Master Capable. Latency=66. Min Gnt=8.Max Lat=56.
Prefetchable 32 bit memory at 0x0 [0x8].
I/O at 0x5800 [0x5801].
Bus 0, device 13, function 0:
SCSI storage controller: Adaptec AIC-7880U (rev 0).
Medium devsel. Fast back-to-back capable. IRQ 11. Master Capable. Latency=64. Min Gnt=8.Max Lat=8.
I/O at 0xfc00 [0xfc01].
Non-prefetchable 32 bit memory at 0xfe9ff000 [0xfe9ff000].
Bus 0, device 18, function 0:
ISA bridge: Intel 82371SB PIIX3 ISA (rev 1).
Medium devsel. Fast back-to-back capable. Master Capable. No bursts.
Bus 0, device 18, function 1:
IDE interface: Intel 82371SB PIIX3 IDE (rev 0).
Medium devsel. Fast back-to-back capable. Master Capable. Latency=64.
I/O at 0xffa0 [0xffa1].
Bus 0, device 20, function 0:
VGA compatible controller: Cirrus Logic GD 5430 (rev 34).
Medium devsel.
Prefetchable 32 bit memory at 0xfb000000 [0xfb000008].
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/