I have a question here. I inserted a module in the
network layer(between IP and device driver). The purpose is to do some
bandwidth control on this psuedo layer. All packets would go to the
module then go to the device driver, and all incoming packet will go to
the module first too.(derived from shaper module)
I set up this module on both ends. How do I create packets on this layer
to let them pass massage to each other?
I tried to look in the source code, and found the packet construction is
like BSD socket--> INET socket--> protocol layer--> device driver.
BSD need to use like sys_socket(family,type,protocol) to create packet.
And I am confused if I should use that or something else.
Department of Electrical and Computer Engineering
University of Wisconsin, Madison
To unsubscribe from this list: send the line "unsubscribe linux-net" in
the body of a message to email@example.com
This archive was generated by hypermail 2b29 : Sat Jan 15 2000 - 21:00:30 EST