Re: [PATCH v2 3/4] iio: adc: ad7124: add external clock support

[Andy Shevchenko]

On Tue, Aug 26, 2025 at 1:55 AM David Lechner <dlechner@xxxxxxxxxxxx> wrote:
>
> Add support for an external clock source to the AD7124 ADC driver.
>
> Previously, the driver only supported using the internal clock and had
> bad devicetree bindings that used a fake clock to essentially select
> the power mode. This is preserved for backwards compatibility.
>
> If the clock is not named "mclk", then we know that the devicetree is
> using the correct bindings and we can configure the chip to use an
> external clock source rather than internal.
>
> Also drop a redundant comment when configuring the register fields
> instead of adding more.

...

> +                       /*
> +                        * The external clock may be 4x the nominal clock rate,
> +                        * in which case the ADC needs to be configured to
> +                        * divide it by 4. Using MEGA is a bit arbitrary, but
> +                        * the expected clock rates are either 614.4 kHz or
> +                        * 2.4576 MHz, so this should work.
> +                        */
> +                       if (clk_hz > MEGA)

This is (1 * HZ_PER_MHZ), but as the comment says, this arbitrary
check may be improved by using the exact values.

> +                               clk_sel = AD7124_ADC_CONTROL_CLK_SEL_EXT_DIV4;
> +                       else
> +                               clk_sel = AD7124_ADC_CONTROL_CLK_SEL_EXT;

-- 
With Best Regards,
Andy Shevchenko