Re: [PATCH v5 1/4] arm64: dts: ti: k3-am62p5-sk: Remove the unused cfg in USB1_DRVVBUS

[Kendall Willis]

On 9/5/25 00:14, Akashdeep Kaur wrote:
> After the SoC has entered the DeepSleep low power mode, USB1 can be used
> to wakeup the SoC based on USB events triggered by USB devices. This
> requires that the pin corresponding to the Type-A connector remains pulled
> up even after the SoC has entered the DeepSleep low power mode.
> For that, either DeepSleep pullup configuration can be selected or the pin
> can have the same configuration that it had when SoC was in active mode.
> But, in order for DeepSleep configuration to take effect, the DeepSleep
> control bit has to be enabled.

The last sentence wording is confusing because it sounds like a 
DeepSleep control bit still needs to be enabled which is not seen in the 
patch. If possible, drop this sentence and do the same for the other 
similar patch in this series.

> Remove the unnecessary DeepSleep state configuration from USB1_DRVBUS pin,
> as the DeepSleep control bit is not set and the active configuration is
> sufficient to keep the pin pulled up. This simplifies the setup and removes
> redundant configuration.
>
> This reverts commit 115290c112952db27009668aa7ae2f29920704f0.
>
> Reviewed-by: Dhruva Gole <d-gole@xxxxxx>
> Signed-off-by: Akashdeep Kaur <a-kaur@xxxxxx>

Verified USB disconnect, USB connect, and USB remote wakeup on AM62P SKEVM.

Tested-by: Kendall Willis <k-willis@xxxxxx>

> ---
>   arch/arm64/boot/dts/ti/k3-am62p5-sk.dts | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-am62p5-sk.dts b/arch/arm64/boot/dts/ti/k3-am62p5-sk.dts
> index 899da7896563..e8f0ac2c55e2 100644
> --- a/arch/arm64/boot/dts/ti/k3-am62p5-sk.dts
> +++ b/arch/arm64/boot/dts/ti/k3-am62p5-sk.dts
> @@ -360,7 +360,7 @@ AM62PX_IOPAD(0x01b0, PIN_OUTPUT, 2) /* (G20) MCASP0_ACLKR.UART1_TXD */
>   
>   	main_usb1_pins_default: main-usb1-default-pins {
>   		pinctrl-single,pins = <
> -			AM62PX_IOPAD(0x0258, PIN_INPUT | PIN_DS_PULLUD_ENABLE | PIN_DS_PULL_UP, 0) /* (G21) USB1_DRVVBUS */
> +			AM62PX_IOPAD(0x0258, PIN_INPUT, 0) /* (G21) USB1_DRVVBUS */
>   		>;
>   	};
>