Re: [PATCH v3 8/8] ARM: dts: r9a06g032: Add support for GPIO interrupts

[Herve Codina]

On Fri, 19 Sep 2025 16:41:05 +0200
Wolfram Sang <wsa+renesas@xxxxxxxxxxxxxxxxxxxx> wrote:

> > 'interrupt-map' is a required property. If the board doesn't use any interrupt
> > GPIO, its dts has no reason to set the interrupt-map.  
> 
> Why is 'interrupt-map' then a required property? Can we drop it from the
> requirements?
> 

I need to check in details but 'interrupt-map' should be kept required.
Indeed, irq-mux needs this property to work. It is not an optional one.

I need to look at the 'make CHECK_DTBS=y' behavior when required property is
missing in a not enabled node (node with status = "disabled").

Also, got some:
   Warning (interrupts_property): /soc/interrupt-controller@51000480: Missing interrupt-controller or interrupt-map property

This could be due to the presence of #interrupt-cells or the node name (not
sure). As I need to rename the node (Conor's comment), I will see if the
warning disappear. If the warning is due to #interrupt-cells, I don't think
that removing #interrupt-cells is the right solution to avoid the warning.

That's said, I need to perform some local tries. I will keep you informed.

Best regards
Hervé