[PATCH 02/24] arm64: defconfig: Enable Glymur configs for boot to shell

[Pankaj Patil]

The serial engine must be properly setup before kernel reaches
"init",so UART driver and its dependencies needs to be built in.
Enable its dependency clocks,interconnect and pinctrl as built-in
to boot Glymur CRD board to UART console with full USB support.

Signed-off-by: Pankaj Patil <pankaj.patil@xxxxxxxxxxxxxxxx>
---
 arch/arm64/configs/defconfig | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig
index e3a2d37bd10423b028f59dc40d6e8ee1c610d6b8..9dfec01d347b57b4eae1621a69dc06bb8ecbdff1 100644
--- a/arch/arm64/configs/defconfig
+++ b/arch/arm64/configs/defconfig
@@ -616,6 +616,7 @@ CONFIG_PINCTRL_IMX8ULP=y
 CONFIG_PINCTRL_IMX91=y
 CONFIG_PINCTRL_IMX93=y
 CONFIG_PINCTRL_MSM=y
+CONFIG_PINCTRL_GLYMUR=y
 CONFIG_PINCTRL_IPQ5018=y
 CONFIG_PINCTRL_IPQ5332=y
 CONFIG_PINCTRL_IPQ5424=y
@@ -1363,6 +1364,9 @@ CONFIG_COMMON_CLK_MT8192_SCP_ADSP=y
 CONFIG_COMMON_CLK_MT8192_VDECSYS=y
 CONFIG_COMMON_CLK_MT8192_VENCSYS=y
 CONFIG_COMMON_CLK_QCOM=y
+CONFIG_CLK_GLYMUR_DISPCC=y
+CONFIG_CLK_GLYMUR_GCC=y
+CONFIG_CLK_GLYMUR_TCSRCC=y
 CONFIG_CLK_X1E80100_CAMCC=m
 CONFIG_CLK_X1E80100_DISPCC=m
 CONFIG_CLK_X1E80100_GCC=y
@@ -1641,6 +1645,7 @@ CONFIG_PHY_QCOM_QMP=m
 CONFIG_PHY_QCOM_QUSB2=m
 CONFIG_PHY_QCOM_EUSB2_REPEATER=m
 CONFIG_PHY_QCOM_M31_USB=m
+CONFIG_PHY_QCOM_M31_EUSB=m
 CONFIG_PHY_QCOM_USB_HS=m
 CONFIG_PHY_QCOM_USB_SNPS_FEMTO_V2=m
 CONFIG_PHY_QCOM_USB_HS_28NM=m
@@ -1718,6 +1723,7 @@ CONFIG_INTERCONNECT_IMX8MN=m
 CONFIG_INTERCONNECT_IMX8MQ=m
 CONFIG_INTERCONNECT_IMX8MP=y
 CONFIG_INTERCONNECT_QCOM=y
+CONFIG_INTERCONNECT_QCOM_GLYMUR=y
 CONFIG_INTERCONNECT_QCOM_MSM8916=m
 CONFIG_INTERCONNECT_QCOM_MSM8996=y
 CONFIG_INTERCONNECT_QCOM_OSM_L3=m

-- 
2.34.1