Re: [PATCH 2/5] arm64: dts: qcom: r0q: add touchscreen support

[Eric Gonçalves]

On September 25, 2025 10:08:37 AM GMT-03:00, Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx> wrote:
>On 9/20/25 3:46 AM, Eric Gonçalves wrote:
>> Enable the ST-Microelectronics FTS2BA61Y touchscreen. This patch
>> depends on "Input: add support for the STM FTS2BA61Y touchscreen".
>> 
>> The device has an issue where SPI 8 (the bus which the touchscreen is
>> connected to) is not working properly right now, so
>> spi-gpio is used instead.
>> 
>> Signed-off-by: Eric Gonçalves <ghatto404@xxxxxxxxx>
>> ---
>
>[...]
>
>>  &tlmm {
>>  	gpio-reserved-ranges = <36 4>; /* SPI (Unused) */
>> +
>> +	spi_clk_tsp_active: spi_clk_tsp_active {
>> +		mux {
>> +			pins = "gpio30";
>> +			function = "gpio";
>> +		};
>> +		config {
>> +			pins = "gpio30";
>> +			drive-strength = <6>;
>> +			bias-disable;
>> +		};
>> +	};
>
>Drop mux/config, put all the properties right under the pin definition
>
>> +
>> +	spi_clk_tsp_sleep: spi_clk_tsp_sleep {
>
>Underscores are forbidden in node names, use dashes instead
>
>Konrad
Will do, thanks