Re: [PATCH v2 0/3] Add support for AD5706R DAC

[Andy Shevchenko]

On Wed, Mar 11, 2026 at 08:23:16AM +0800, Alexis Czezar Torreno wrote:
> This series adds support for the Analog Devices AD5706R, a 4-channel
> 16-bit current output digital-to-analog converter with SPI interface.
> 
> The AD5706R features:
>   - 4 independent current output DAC channels
>   - Configurable output ranges (50mA, 150mA, 200mA, 300mA)
>   - Hardware and software LDAC trigger with configurable edge selection
>   - Toggle and dither modes per channel
>   - Internal or external voltage reference selection
>   - PWM-controlled LDAC
>   - Dynamic change SPI speed
> 
> The driver exposes standard IIO raw/scale/offset channel attributes for
> DAC output control, sampling frequency for PWM-based LDAC timing, and
> extended attributes for device configuration including output range
> selection, trigger mode, and multiplexer output.
> 
> This driver is developed and tested on the Cora Z7S platform using
> the AXI SPI Engine and AXI CLKGEN IP cores. The 'clocks' property
> enables dynamic SPI clock rate management via the CLKGEN.
> 
> Datasheet: https://www.analog.com/en/products/ad5706r.html

It's a v2 and still some very basic comments may be applied, such an
introduction of the record in MAINTAINERS database.

One more time, can't ADI introduce an internal Wiki page where standard
practices and/or typical issues be listed and be addressed BEFORE it's going to
the mailing lists?

-- 
With Best Regards,
Andy Shevchenko