Re: [RFC net-next v2 0/6] ethtool: Generic loopback support

[Russell King (Oracle)]

On Wed, Mar 11, 2026 at 01:32:09PM +0100, Andrew Lunn wrote:
> > > > With a SERDES component, the mapping becomes cleaner:
> > > >   component  name         supported
> > > >   MAC        mac          near-end
> > > >   SERDES     serdes-ned   near-end
> > > >   SERDES     serdes-nea   near-end
> > > >   SERDES     serdes-fed   far-end
> > > 
> > > If Linux where to drive the SERDES, what part of Linux would it be?
> > > Generic PHY? How does your SERDES hardware block fit into 802.3? Which
> > > clause describes it?
> > 
> > Hi Andrew,
> > 
> > On OcteonTx2 SoC, the SerDes (GSERM) is a HW block integrated into the
> > SoC die. It is not on an MDIO bus or any bus that Linux can enumerate.
> > The block is fully managed by the firmware running on the SoC. The NIC
> > driver configures it indirectly through firmware mailbox commands.
> > 
> > The data path looks like:
> >   MAC (RPM) --- SerDes (GSERM) --- module/PHY
> > 
> > In 802.3 terms, the closest match would be PMA. The GSERM handles
> > serialization/deserialization and the analog front-end.
> 
> A Linux Generic PHY is probably also PMA.
> 
> 802.3 says very little about SERDES, it is not a well defined term. So
> i think we want PCS and PMA, not SERDES as a loopback point.

That's a good point. I'm wondeirng whether to change "serdes" /
"SerDes" in my stmmac patches to be "pma".

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!