[PATCH net-next v2 0/2] Add support for PIC64-HPSC/HX MDIO controller

[Charles Perry]

Hello,

This series adds a driver for the two MDIO controllers of PIC64-HPSC/HX.
The hardware supports C22 and C45 but only C22 is implemented for now.

This MDIO hardware is based on a Microsemi design supported in Linux by
mdio-mscc-miim.c. However, The register interface is completely different
with pic64hpsc, hence the need for a separate driver.

The documentation recommends an input clock of 156.25MHz and a prescaler of
39, which yields an MDIO clock of 1.95MHz.

This was tested on Microchip HB1301 evalkit which has a VSC8574 and a
VSC8541 with clock frequencies of 0.6, 1.95 and 2.5 MHz.

Thanks,
Charles

Changes in v2:
- 1/2: Make "clocks" and "interrupts" required (Andrew)
- 1/2: Add a default value to "clock-frequency" (Andrew)
- 2/2: Remove #define for unused registers (Maxime)
- 2/2: Add "c22" to clause 22 read/write ops (Maxime)
- 2/2: Remove the call to platform_set_drvdata() (Andrew)
- 2/2: Make the clock mandatory (Andrew)
- 2/2: Use 2.5MHz if no clock-frequency was specified (Andrew)
- 2/2: Change the error message for bad clock-frequency (Andrew)
- 2/2: Fix a use without initialization on bus_freq (Andrew)

Charles Perry (2):
  dt-bindings: net: document Microchip PIC64-HPSC/HX MDIO controller
  net: mdio: add a driver for PIC64-HPSC/HX MDIO controller

 .../net/microchip,pic64hpsc-mdio.yaml         |  68 +++++++
 drivers/net/mdio/Kconfig                      |   7 +
 drivers/net/mdio/Makefile                     |   1 +
 drivers/net/mdio/mdio-pic64hpsc.c             | 192 ++++++++++++++++++
 4 files changed, 268 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/microchip,pic64hpsc-mdio.yaml
 create mode 100644 drivers/net/mdio/mdio-pic64hpsc.c

-- 
2.47.3