[PATCH V3 2/3] arm64: dts: imx95-15x15-evk: Disable PCIe bus in the default dts

[Sherry Sun]

Disable the PCIe bus in the default device tree to avoid shared
regulator conflicts between SDIO and PCIe buses. The non-deterministic
probe order between these two buses can break the PCIe initialization
sequence, causing PCIe devices to fail detection intermittently.

On i.MX95-15x15 EVK board, the M.2 connector is physically wired to both
USDHC3 and PCIe0, however the out-of-box module is SDIO IW612 WiFi, so
enable SDIO WiFi in the default imx95-15x15-evk.dts.

Add 'm2_usdhc' label to USDHC3 to support device tree overlay for PCIe
modules. Users who need PCIe can use imx95-15x15-evk-pcie.dtb (added in
a follow-up patch) which applies an overlay to enable PCIe and disable
USDHC3.

Signed-off-by: Sherry Sun <sherry.sun@xxxxxxx>
---
 arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
index 7eb12e7d5014..e4649d7f9122 100644
--- a/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx95-15x15-evk.dts
@@ -557,7 +557,7 @@ &pcie0 {
 	vpcie-supply = <&reg_m2_pwr>;
 	vpcie3v3aux-supply = <&reg_m2_pwr>;
 	supports-clkreq;
-	status = "okay";
+	status = "disabled";
 };
 
 &pcie0_ep {
@@ -1137,7 +1137,7 @@ &usdhc2 {
 	status = "okay";
 };
 
-&usdhc3 {
+m2_usdhc: &usdhc3 {
 	bus-width = <4>;
 	keep-power-in-suspend;
 	mmc-pwrseq = <&usdhc3_pwrseq>;
-- 
2.37.1