Re: [PATCH net-next] net: sfp: add quirk for ZOERAX SFP-2.5G-T

[Jakub Kicinski]

On Wed, 25 Mar 2026 17:35:58 +0100 Jan Hoffmann wrote:
> This is a 2.5G copper module which appears to be based on a Motorcomm
> YT8821 PHY. There doesn't seem to be a usable way to to access the PHY
> (I2C address 0x56 provides only read-only C22 access, and Rollball is
> also not working).
> 
> The module does not report the correct extended compliance code for
> 2.5GBase-T, and instead claims to support SONET OC-48 and Fibre Channel:
> 
>   Identifier          : 0x03 (SFP)
>   Extended identifier : 0x04 (GBIC/SFP defined by 2-wire interface ID)
>   Connector           : 0x07 (LC)
>   Transceiver codes   : 0x00 0x01 0x00 0x00 0x40 0x40 0x04 0x00 0x00
>   Transceiver type    : FC: Multimode, 50um (M5)
>   Encoding            : 0x05 (SONET Scrambled)
>   BR Nominal          : 2500MBd
> 
> Despite this, the kernel still sets 2500Base-X as interface mode based
> on the (incorrect) nominal signaling rate.
> 
> However, it is also necessary to disable auto-negotiation for the module
> to actually work. Thus, create a SFP quirk to do this.
> 
> Signed-off-by: Jan Hoffmann <jan@xxxxxx>
> ---
> Note: I'm not quite sure "sfp_quirk_disable_autoneg" is enough here, or
> if it would be appropriate to use the full "sfp_quirk_oem_2_5g" quirk
> due to the not really correct compliance code / nominal signaling rate.

I'm no SFP expert but just going by the naming I strongly suspect that
the module is the same hardware as "SFP-2.5G-T" from "FS", so keeping
quirks consistent makes sense?