Re: [PATCH v4 0/5] Add initial Milk-V Duo S board support

[Joshua Milas]

Hi Michael,

Thanks for testing this. I am not seeing that issue on my arm64 or riscv side.
I am able to add an IP and do anything I can think of on the arm64 side.

[   96.618687] stmmaceth 4070000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
[   96.633977] stmmaceth 4070000.ethernet eth0: PHY [mdio_mux-0.0:01] driver [Generic PHY] (irq=POLL)
[   96.676436] dwmac1000: Master AXI performs any burst length
[   96.702852] stmmaceth 4070000.ethernet eth0: No Safety Features support found
[   96.748740] stmmaceth 4070000.ethernet eth0: IEEE 1588-2002 Timestamp supported
[   96.772880] stmmaceth 4070000.ethernet eth0: configuring for phy/internal link mode
[ 1359.377528] stmmaceth 4070000.ethernet eth0: Link is Up - 100Mbps/Full - flow control off

I can do the same on the riscv side but get a unhandled signal for TLS traffic
which I believe is unrelated as it doesn't happen on adding an IP.

I'll send over my configs to see if that helps.

Have a great day,
- Joshua Milas