[PATCH v3 2/5] Bluetooth: btusb: fix use-after-free on marvell probe failure

[Johan Hovold]

Make sure to stop any TX URBs submitted during Marvell OOB wakeup
configuration on later probe failures to avoid use-after-free in the
completion callback.

This issue was reported by Sashiko while reviewing a fix for a wakeup
source leak in the btusb probe errors paths.

Link: https://sashiko.dev/#/patchset/20260402092704.2346710-1-johan%40kernel.org
Fixes: a4ccc9e33d2f ("Bluetooth: btusb: Configure Marvell to use one of the pins for oob wakeup")
Cc: stable@xxxxxxxxxxxxxxx	# 4.11
Cc: Rajat Jain <rajatja@xxxxxxxxxx>
Signed-off-by: Johan Hovold <johan@xxxxxxxxxx>
---
 drivers/bluetooth/btusb.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 97de6e6e7dbc..b6f2bed7d1b8 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -4183,7 +4183,7 @@ static int btusb_probe(struct usb_interface *intf,
 	if (id->driver_info & BTUSB_INTEL_COMBINED) {
 		err = btintel_configure_setup(hdev, btusb_driver.name);
 		if (err)
-			goto out_free_dev;
+			goto err_kill_tx_urbs;
 
 		/* Transport specific configuration */
 		hdev->send = btusb_send_frame_intel;
@@ -4346,7 +4346,7 @@ static int btusb_probe(struct usb_interface *intf,
 		err = usb_set_interface(data->udev, 0, 0);
 		if (err < 0) {
 			BT_ERR("failed to set interface 0, alt 0 %d", err);
-			goto out_free_dev;
+			goto err_kill_tx_urbs;
 		}
 	}
 
@@ -4354,7 +4354,7 @@ static int btusb_probe(struct usb_interface *intf,
 		err = usb_driver_claim_interface(&btusb_driver,
 						 data->isoc, data);
 		if (err < 0)
-			goto out_free_dev;
+			goto err_kill_tx_urbs;
 	}
 
 	if (IS_ENABLED(CONFIG_BT_HCIBTUSB_BCM) && data->diag) {
@@ -4390,6 +4390,8 @@ static int btusb_probe(struct usb_interface *intf,
 		usb_set_intfdata(data->isoc, NULL);
 		usb_driver_release_interface(&btusb_driver, data->isoc);
 	}
+err_kill_tx_urbs:
+	usb_kill_anchored_urbs(&data->tx_anchor);
 out_free_dev:
 	if (data->reset_gpio)
 		gpiod_put(data->reset_gpio);
-- 
2.52.0