[PATCH 1/2] wifi: rtw89: phy: increase RF calibration timeouts for USB transport

[Louis Kotze]

USB transport adds significant latency to H2C/C2H round-trips used
by RF calibration. The existing timeout values were designed for PCIe
and are too tight for USB, causing "failed to wait RF DACK",
"failed to wait RF TSSI" and similar errors on USB adapters.

Apply a 4x timeout multiplier when the device uses USB transport.
The multiplier is applied in rtw89_phy_rfk_report_wait() so all
calibrations benefit without changing any call sites or PCIe
timeout values.

The 4x multiplier was chosen based on measured data from two
independent testers (RTL8922AU, 6GHz MLO and 2.4/5GHz):

  Calibration   PCIe timeout   Max measured (USB)   4x timeout
  PRE_NTFY           5ms              1ms              20ms
  DACK              58ms             72ms             232ms
  RX_DCK           128ms            374ms             512ms
  TSSI normal       20ms             24ms              80ms
  TSSI scan          6ms             14ms              24ms
  TXGAPK            54ms             18ms             216ms
  IQK               84ms             53ms             336ms
  DPK               34ms             30ms             136ms

Tested with RTL8922AU on 6GHz MLO (5GHz + 6GHz simultaneous):
25 connect/disconnect cycles with zero failures.

Signed-off-by: Louis Kotze <loukot@xxxxxxxxx>
---
 drivers/net/wireless/realtek/rtw89/phy.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/net/wireless/realtek/rtw89/phy.c b/drivers/net/wireless/realtek/rtw89/phy.c
index e70d0e283..4d809df8b 100644
--- a/drivers/net/wireless/realtek/rtw89/phy.c
+++ b/drivers/net/wireless/realtek/rtw89/phy.c
@@ -3956,6 +3956,13 @@ int rtw89_phy_rfk_report_wait(struct rtw89_dev *rtwdev, const char *rfk_name,
 	struct rtw89_rfk_wait_info *wait = &rtwdev->rfk_wait;
 	unsigned long time_left;
 
+	/* USB transport adds latency to H2C/C2H round-trips, so RF
+	 * calibrations take longer than on PCIe. Apply a 4x multiplier
+	 * to avoid spurious timeouts.
+	 */
+	if (rtwdev->hci.type == RTW89_HCI_TYPE_USB)
+		ms *= 4;
+
 	/* Since we can't receive C2H event during SER, use a fixed delay. */
 	if (test_bit(RTW89_FLAG_SER_HANDLING, rtwdev->flags)) {
 		fsleep(1000 * ms / 2);
-- 
2.53.0