Re: [PATCH v5 net-next 0/8] dpll/ice: Add TXC DPLL type and full TX reference clock control for E825

[Jakub Kicinski]

On Fri, 10 Apr 2026 14:23:58 +0000 Nitka, Grzegorz wrote:
> Here is the high-level connection diagram for E825 device. I hope you find it helpful:
> [..]

It does thanks a lot.

> Before this series, we tried different approaches.
> One of them was to create MUX pin associated with netdev interface.
> EXT_REF and SYNCE pins were registered with this MUX pin.
> However I recall there were at least two issues with this solution:
> - when using DPLL subsystem not all the connections/relations were visible
>   from DPLL pin-get perspective. RT netlink was required
> - due to mixing pins from different modules (like fwnode based pin from zl driver
>   and the pins from ice), we were not able to safely clean the references between
>   pins and dpll (basicaly .. we observed crashes)
> 
> Proposed solution just seems to be clean and fully reflects current
> connection topology.

Do you have the link to the old proposal that was adding stuff to
rtnetlink? I remember some discussion long-ish ago, maybe I was wrong.

> What's actually your biggest concern?
> The fact we introduce a new DPLL type? Or multiply DPLL instances? Or both?
> Do you prefer to see "one big" DPLL with 16 pins in our case (8 ports x 2 tx-clk pins)?
> Each pin with the name like, for example, PF0-SyncE/PF0-eRef etc.?

My concern is that I think this is a pretty run of the mill SyncE
design. If we need to pretend we have two DPLLs here if we really
only have one and a mux - then our APIs are mis-designed :(