[PATCH net,v2 1/1] net: stmmac: Update default_an_inband before passing value to phylink_config

[KhaiWenTan]

get_interfaces() will update both the plat->phy_interfaces and
mdio_bus_data->default_an_inband based on reading a SERDES register. As
get_interfaces() will be called after default_an_inband had already been
read, dwmac-intel regressed as a result with incorrect default_an_inband
value in phylink_config.

Therefore, we moved the priv->plat->get_interfaces() to be executed first
before assigning mdio_bus_data->default_an_inband to
config->default_an_inband to ensure default_an_inband is in correct value.

Fixes: d3836052fe09 ("net: stmmac: intel: convert speed_mode_2500() to get_interfaces()")
Signed-off-by: KhaiWenTan <khai.wen.tan@xxxxxxxxxxxxxxx>
---
v2:
  - update commit message for better understanding (Russell King)
  - corrected the blamed commit (Russell King)
v1: https://patchwork.kernel.org/project/netdevbpf/patch/20260410020735.327590-1-khai.wen.tan@xxxxxxxxxxxxxxx/
---
 drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 13d3cac056be..c92054648a7e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1345,10 +1345,6 @@ static int stmmac_phylink_setup(struct stmmac_priv *priv)
 	priv->tx_lpi_clk_stop = priv->plat->flags &
 				STMMAC_FLAG_EN_TX_LPI_CLOCKGATING;
 
-	mdio_bus_data = priv->plat->mdio_bus_data;
-	if (mdio_bus_data)
-		config->default_an_inband = mdio_bus_data->default_an_inband;
-
 	/* Get the PHY interface modes (at the PHY end of the link) that
 	 * are supported by the platform.
 	 */
@@ -1356,6 +1352,10 @@ static int stmmac_phylink_setup(struct stmmac_priv *priv)
 		priv->plat->get_interfaces(priv, priv->plat->bsp_priv,
 					   config->supported_interfaces);
 
+	mdio_bus_data = priv->plat->mdio_bus_data;
+	if (mdio_bus_data)
+		config->default_an_inband = mdio_bus_data->default_an_inband;
+
 	/* Set the platform/firmware specified interface mode if the
 	 * supported interfaces have not already been provided using
 	 * phy_interface as a last resort.
-- 
2.43.0