Re: [net,PATCH v3 1/2] net: ks8851: Reinstate disabling of BHs around IRQ handler

[Marek Vasut]

On 4/14/26 2:57 PM, Sebastian Andrzej Siewior wrote:
> On 2026-04-14 12:32:52 [+0200], Marek Vasut wrote:
> > If CONFIG_PREEMPT_RT=y is set AND the driver executes ks8851_irq() AND
> > KSZ_ISR register bit IRQ_RXI is set AND ks8851_rx_pkts() detects that
> > there are packets in the RX FIFO, then netdev_alloc_skb_ip_align() is
> > called to allocate SKBs. If netdev_alloc_skb_ip_align() is called with
> > BH enabled, local_bh_enable() at the end of netdev_alloc_skb_ip_align()
> > will call __local_bh_enable_ip(), which will call __do_softirq(), which
> > may trigger net_tx_action() softirq, which may ultimately call the xmit
> > callback ks8851_start_xmit_par(). The ks8851_start_xmit_par() will try
> > to lock struct ks8851_net_par .lock spinlock, which is already locked
> > by ks8851_irq() from which ks8851_start_xmit_par() was called. This
> > leads to a deadlock, which is reported by the kernel, including a trace
> > listed below.
>
> #1 [received RX packet and a] TX packet has been sent
> #2 Driver enables TX queue via netif_wake_queue() which schedules TX
>     softirq to queue packets for this device.
> #2 After spin_unlock_bh(&ks->statelock) the pending softirqs will be
>     processed
> #3 This deadlocks because of recursive locking via ks8851_net::lock in
>     ks8851_irq() and ks8851_start_xmit_par().
>
> This is what happens since commit 0913ec336a6c0 ("net: ks8851: Fix
> deadlock with the SPI chip variant"). Before that commit the softirq
> execution will be picked up by netdev_alloc_skb_ip_align() and requires
> PREEMPT_RT and a RX packet in #1 to trigger the deadlock.

Do you want me to add this into the V4 commit message ?

> > Fix the problem by disabling BH around critical sections, including the
> > IRQ handler, thus preventing the net_tx_action() softirq from triggering
> > during these critical sections. The net_tx_action() softirq is triggered
> > at the end of the IRQ handler, once all the other IRQ handler actions have
> > been completed.
> >
> >   __schedule from schedule_rtlock+0x1c/0x34
> >   schedule_rtlock from rtlock_slowlock_locked+0x548/0x904
> >   rtlock_slowlock_locked from rt_spin_lock+0x60/0x9c
> >   rt_spin_lock from ks8851_start_xmit_par+0x74/0x1a8
> >   ks8851_start_xmit_par from netdev_start_xmit+0x20/0x44
> >   netdev_start_xmit from dev_hard_start_xmit+0xd0/0x188
> >   dev_hard_start_xmit from sch_direct_xmit+0xb8/0x25c
> >   sch_direct_xmit from __qdisc_run+0x1f8/0x4ec
> >   __qdisc_run from qdisc_run+0x1c/0x28
> >   qdisc_run from net_tx_action+0x1f0/0x268
> >   net_tx_action from handle_softirqs+0x1a4/0x270
> >   handle_softirqs from __local_bh_enable_ip+0xcc/0xe0
> >   __local_bh_enable_ip from __alloc_skb+0xd8/0x128
> >   __alloc_skb from __netdev_alloc_skb+0x3c/0x19c
> >   __netdev_alloc_skb from ks8851_irq+0x388/0x4d4
> >   ks8851_irq from irq_thread_fn+0x24/0x64
> >   irq_thread_fn from irq_thread+0x178/0x28c
> >   irq_thread from kthread+0x12c/0x138
> >   kthread from ret_from_fork+0x14/0x28
>
> The backtrace here and the description is based on an older kernel.
> However
I actually did update the backtrace in V3 with the one from current next 
20260413 .