[net-next PATCH v2 1/8] net: dsa: realtek: rtl8365mb: use ERR_PTR

[Luiz Angelo Daros de Luca]

Convert numeric error codes into human-readable strings by
using %pe together with ERR_PTR() in dev_err() messages.

Signed-off-by: Luiz Angelo Daros de Luca <luizluca@xxxxxxxxx>
---
 drivers/net/dsa/realtek/rtl8365mb.c | 40 ++++++++++++++++++++-----------------
 1 file changed, 22 insertions(+), 18 deletions(-)

diff --git a/drivers/net/dsa/realtek/rtl8365mb.c b/drivers/net/dsa/realtek/rtl8365mb.c
index c35cef01ec26..edbc16345d0d 100644
--- a/drivers/net/dsa/realtek/rtl8365mb.c
+++ b/drivers/net/dsa/realtek/rtl8365mb.c
@@ -789,8 +789,8 @@ static int rtl8365mb_phy_read(struct realtek_priv *priv, int phy, int regnum)
 	ret = rtl8365mb_phy_ocp_read(priv, phy, ocp_addr, &val);
 	if (ret) {
 		dev_err(priv->dev,
-			"failed to read PHY%d reg %02x @ %04x, ret %d\n", phy,
-			regnum, ocp_addr, ret);
+			"failed to read PHY%d reg %02x @ %04x, ret %pe\n", phy,
+			regnum, ocp_addr, ERR_PTR(ret));
 		return ret;
 	}
 
@@ -817,8 +817,8 @@ static int rtl8365mb_phy_write(struct realtek_priv *priv, int phy, int regnum,
 	ret = rtl8365mb_phy_ocp_write(priv, phy, ocp_addr, val);
 	if (ret) {
 		dev_err(priv->dev,
-			"failed to write PHY%d reg %02x @ %04x, ret %d\n", phy,
-			regnum, ocp_addr, ret);
+			"failed to write PHY%d reg %02x @ %04x, ret %pe\n", phy,
+			regnum, ocp_addr, ERR_PTR(ret));
 		return ret;
 	}
 
@@ -1068,8 +1068,8 @@ static void rtl8365mb_phylink_mac_config(struct phylink_config *config,
 		ret = rtl8365mb_ext_config_rgmii(priv, port, state->interface);
 		if (ret)
 			dev_err(priv->dev,
-				"failed to configure RGMII mode on port %d: %d\n",
-				port, ret);
+				"failed to configure RGMII mode on port %d: %pe\n",
+				port, ERR_PTR(ret));
 		return;
 	}
 
@@ -1098,8 +1098,8 @@ static void rtl8365mb_phylink_mac_link_down(struct phylink_config *config,
 						     false, false);
 		if (ret)
 			dev_err(priv->dev,
-				"failed to reset forced mode on port %d: %d\n",
-				port, ret);
+				"failed to reset forced mode on port %d: %pe\n",
+				port, ERR_PTR(ret));
 
 		return;
 	}
@@ -1129,8 +1129,8 @@ static void rtl8365mb_phylink_mac_link_up(struct phylink_config *config,
 						     rx_pause);
 		if (ret)
 			dev_err(priv->dev,
-				"failed to force mode on port %d: %d\n", port,
-				ret);
+				"failed to force mode on port %d: %pe\n", port,
+				ERR_PTR(ret));
 
 		return;
 	}
@@ -1285,8 +1285,8 @@ static void rtl8365mb_get_ethtool_stats(struct dsa_switch *ds, int port, u64 *da
 						 mib->length, &data[i]);
 		if (ret) {
 			dev_err(priv->dev,
-				"failed to read port %d counters: %d\n", port,
-				ret);
+				"failed to read port %d counters: %pe\n", port,
+				ERR_PTR(ret));
 			break;
 		}
 	}
@@ -1638,7 +1638,8 @@ static irqreturn_t rtl8365mb_irq(int irq, void *data)
 	return IRQ_HANDLED;
 
 out_error:
-	dev_err(priv->dev, "failed to read interrupt status: %d\n", ret);
+	dev_err(priv->dev, "failed to read interrupt status: %pe\n",
+		ERR_PTR(ret));
 
 out_none:
 	return IRQ_NONE;
@@ -1776,7 +1777,8 @@ static int rtl8365mb_irq_setup(struct realtek_priv *priv)
 	ret = request_threaded_irq(irq, NULL, rtl8365mb_irq, IRQF_ONESHOT,
 				   "rtl8365mb", priv);
 	if (ret) {
-		dev_err(priv->dev, "failed to request irq: %d\n", ret);
+		dev_err(priv->dev, "failed to request irq: %pe\n",
+			ERR_PTR(ret));
 		goto out_remove_irqdomain;
 	}
 
@@ -1952,14 +1954,16 @@ static int rtl8365mb_setup(struct dsa_switch *ds)
 
 	ret = rtl8365mb_reset_chip(priv);
 	if (ret) {
-		dev_err(priv->dev, "failed to reset chip: %d\n", ret);
+		dev_err(priv->dev, "failed to reset chip: %pe\n",
+			ERR_PTR(ret));
 		goto out_error;
 	}
 
 	/* Configure switch to vendor-defined initial state */
 	ret = rtl8365mb_switch_init(priv);
 	if (ret) {
-		dev_err(priv->dev, "failed to initialize switch: %d\n", ret);
+		dev_err(priv->dev, "failed to initialize switch: %pe\n",
+			ERR_PTR(ret));
 		goto out_error;
 	}
 
@@ -2077,8 +2081,8 @@ static int rtl8365mb_detect(struct realtek_priv *priv)
 
 	ret = rtl8365mb_get_chip_id_and_ver(priv->map, &chip_id, &chip_ver);
 	if (ret) {
-		dev_err(priv->dev, "failed to read chip id and version: %d\n",
-			ret);
+		dev_err(priv->dev, "failed to read chip id and version: %pe\n",
+			ERR_PTR(ret));
 		return ret;
 	}
 

-- 
2.53.0