Re: [PATCH v4 06/17] iio: magnetometer: ak8975: modernize polling loops with iopoll() macros

[Andy Shevchenko]

On Tue, May 05, 2026 at 09:07:30AM +0200, Joshua Crofts wrote:
> On Tue, 5 May 2026 at 06:58, Andy Shevchenko
> <andriy.shevchenko@xxxxxxxxxxxxxxx> wrote:
> > On Mon, May 04, 2026 at 04:06:06PM +0100, Jonathan Cameron wrote:
> > > On Mon, 04 May 2026 11:48:18 +0200
> > > Joshua Crofts via B4 Relay <devnull+joshua.crofts1.gmail.com@xxxxxxxxxx> wrote:

...

> > > One question inline on whether it is a good idea to be paranoid about
> > > gpiod_get_value() potentially returning < 0 to indicate an error.
> > > Right now that is treated as success.
> >
> > > > +   ret = readx_poll_timeout(gpiod_get_value, data->eoc_gpiod, val, val != 0,
> > > > +                            AK8975_CONVERSION_DONE_POLL_TIME * USEC_PER_MSEC,
> > > > +                            AK8975_MAX_CONVERSION_TIMEOUT * USEC_PER_MSEC);
> > > > +   if (ret)
> > > > +           return ret;
> > >
> > > Should we check val as well?   It might be negative if gpiod_get_value()
> > > returned an error..  Obviously the original code didn't so this would be an
> > > improvement rather than maintaining what that was doing.
> >
> > I agree that this would be a good addition, but since it's a behavioural change
> > I think the separate patch should be made (perhaps after readx_*() conversion
> > as it makes it easier to do).
> 
> Good point, val should definitely be checked. Will send a fix this afternoon.

It's better to integrate it into the series either as a fix (should be first in
the series) or as just an improvement after readx_*() conversion patch.

-- 
With Best Regards,
Andy Shevchenko