Re: [PATCH 1/2] dt-bindings: firmware: document rsu-handle for intel stratix10-svc

[Rob Herring (Arm)]

On Wed, 06 May 2026 05:42:20 -0700, tze.yee.ng@xxxxxxxxxx wrote:
> From: Tze Yee Ng <tze.yee.ng@xxxxxxxxxx>
> 
> Add the optional rsu-handle property to the intel,stratix10-svc binding.
> It holds a phandle to the QSPI boot partition (qspi_boot) for U-Boot
> remote system update (RSU) handoff.
> 
> Extend the example with a minimal QSPI fixed-partitions node so the
> qspi_boot label is defined where rsu-handle is used.
> 
> Signed-off-by: Tze Yee Ng <tze.yee.ng@xxxxxxxxxx>
> ---
>  .../firmware/intel,stratix10-svc.yaml         | 25 +++++++++++++++++++
>  1 file changed, 25 insertions(+)
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/firmware/intel,stratix10-svc.example.dtb: qspi@0 (jedec,spi-nor): $nodename:0: 'qspi@0' does not match '^(flash|.*sram|nand)(@.*)?$'
	from schema $id: http://devicetree.org/schemas/mtd/jedec,spi-nor.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/firmware/intel,stratix10-svc.example.dtb: qspi@0 (jedec,spi-nor): reg:0: [0, 4096] is too long
	from schema $id: http://devicetree.org/schemas/mtd/jedec,spi-nor.yaml
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/firmware/intel,stratix10-svc.example.dtb: qspi@0 (jedec,spi-nor): Unevaluated properties are not allowed ('#address-cells', '#size-cells', 'partitions' were unexpected)
	from schema $id: http://devicetree.org/schemas/mtd/jedec,spi-nor.yaml

doc reference errors (make refcheckdocs):

See https://patchwork.kernel.org/project/devicetree/patch/09822cb8171f90d50c018f2f1fae5e5aab737301.1778070377.git.tze.yee.ng@xxxxxxxxxx

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.