Re: [PATCH 2/2] drm/mediatek: hdmi: report jack plugged state from bridge enable/disable

[Daniel Golle]

On Thu, May 07, 2026 at 12:51:56PM +0300, Dmitry Baryshkov wrote:
> On Wed, Apr 15, 2026 at 04:04:16PM +0100, Daniel Golle wrote:
> > Notify hdmi-codec of the current sink plugged state from
> > mtk_hdmi_bridge_atomic_enable() and mtk_hdmi_bridge_atomic_disable()
> > via mtk_hdmi_update_plugged_status(). This matches the pattern used
> > by dw-hdmi, which invokes handle_plugged_change() from the bridge
> > enable and disable paths so that ASoC jack state stays in sync with
> > the actual sink presence across atomic commit cycles, and not only
> > on CEC HPD transitions.
> > 
> > Userspace audio daemons (e.g. pipewire) rely on the jack state to
> > route streams, restore per-sink volume levels, and recover the last
> > used device after a reconnect. Without this, those transitions are
> > missed whenever the sink change is driven by a mode set rather than
> > by a bare HPD event.
> 
> I can only hope to see mtk_hdmi to migrate to DRM_BRIDGE_OP_HDMI and
> DRM_BRIDGE_OP_HDMI_AUDIO...
> 
> I think the correct timing was discussed several times and the overall
> conclusion was that the correct time is when the actual HDMI cable is
> being plugged / unplugged. See the discussion around [1] and the
> captured response of Mark Brown.

Thank you for bringing this to my attention. I'll follow up on it.
Meanwhile, can (independent) patch 1/2 already be merged, or at least
get reviewed?