Re: [PATCH v2] arm64: dts: qcom: glymur-crd: Move common board nodes to shared DTSI

[Dmitry Baryshkov]

On Tue, May 19, 2026 at 07:25:07AM -0700, Gopikrishna Garmidi wrote:
> The Glymur and Mahua CRDs use the same board-level hardware for the
> eDP display panel, MDSS DP3 controller and PHY, USB-C ports (via
> pmic-glink), USB 0/1/HS/MP controllers, QMP PHYs, eUSB2 repeaters,
> HID peripherals (touchpad, keyboard, touchscreen) and their dependent
> regulators and pin control states. This has been verified against
> both CRD schematics.
> 
> Move these nodes from glymur-crd.dts to glymur-crd.dtsi to enable code
> reuse with the Mahua CRD.
> 
> Signed-off-by: Gopikrishna Garmidi <gopikrishna.garmidi@xxxxxxxxxxxxxxxx>
> ---
> Changes in v2:
> - Rebased on top of next-20260518
> - Updated subject to include glymur-crd scope prefix
> - Rewrote commit message to describe the actual shared physical hardware
>   rather than the code-sharing intent; the commonality was verified
>   against Glymur CRD and Mahua CRD schematics
> - Link to v1: https://lore.kernel.org/r/20260326-glymur-mahua-common-nodes-v1-1-12bb26920ea4@xxxxxxxxxxxxxxxx
> ---
>  arch/arm64/boot/dts/qcom/glymur-crd.dts  | 399 -------------------------------
>  arch/arm64/boot/dts/qcom/glymur-crd.dtsi | 396 ++++++++++++++++++++++++++++++
>  2 files changed, 396 insertions(+), 399 deletions(-)
> 

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxxxxxxxx>


-- 
With best wishes
Dmitry