Re: [PATCH v3] arm64: dts: qcom: lemans-evk: Enable CAN RX via I2C GPIO expander

[Bjorn Andersson]

On Tue, 19 May 2026 12:19:54 +0530, Anup Kulkarni wrote:
> The LeMans EVK board routes the RX lines of CAN controllers 2, 4, and 6
> (part of the RTSS subsystem) through a signal multiplexer controlled by
> GPIO 4 of the I2C GPIO expander at address 0x3b. The remaining CAN
> controllers, out of 8 total on RTSS, are wired directly to their
> transceivers.
> 
> The multiplexer select pin defaults low on reset, disconnecting CAN 2,
> 4, and 6 RX lines from their respective transceivers, which results in
> no data being received on these interfaces.
> 
> [...]

Applied, thanks!

[1/1] arm64: dts: qcom: lemans-evk: Enable CAN RX via I2C GPIO expander
      commit: 89e77275b55eac3d3b8027c9806eb32b24b05023

Best regards,
-- 
Bjorn Andersson <andersson@xxxxxxxxxx>