RE: [PATCH 0/2] Enable RSPI support on RZ/G3L SMARC EVK

[Biju Das]

Hi Geert,

> -----Original Message-----
> From: Geert Uytterhoeven <geert@xxxxxxxxxxxxxx>
> Sent: 02 June 2026 12:07
> Subject: Re: [PATCH 0/2] Enable RSPI support on RZ/G3L SMARC EVK
> 
> Hi Biju,
> 
> On Tue, 19 May 2026 at 13:20, Biju <biju.das.au@xxxxxxxxx> wrote:
> > There is an internal discussion about dropping patch#2, as RSPI is
> > useless without a device connected to that interface. However, as per
> > the schematic, RSPI signals are wired up to the PMOD connector.
> > Currently, it is enabled on RZ/G2L and RZ/G3E. Please share your thoughts on this.
> 
> Sorry, I had missed this question before.
> RZ/G3E SMARC EVK (which shares the same carrier board) has it enabled, too, as the connector is
> labelled "Type-2A", i.e. meant for expanded SPI.  Obviously it really depends on the use case: one
> might want to use the pins as GPIOs?  We can revisit this when we get real connector support.

OK, that makes sense.

Cheers,
Biju

> 
> > Biju Das (2):
> >   arm64: dts: renesas: r9a08g046: Add RSPI{0..2} nodes
> >   arm64: dts: renesas: r9a08g046l48-smarc: Enable RSPI2
> 
> Gr{oetje,eeting}s,
> 
>                         Geert
> 
> --
> Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx
> 
> In personal conversations with technical people, I call myself a hacker. But when I'm talking to
> journalists I just say "programmer" or something like that.
>                                 -- Linus Torvalds