[PATCH v2 2/5] dt-bindings: hwmon: (pmbus/max20830): add VOUT feedback resistor properties

[Alexis Czezar Torreno]

Add adi,vout-rfb1-ohms and adi,vout-rfb2-ohms properties to support
external voltage divider configuration for VOUT sensing. When the
desired output voltage is higher than VREF, a resistor divider (RFB1
and RFB2) is required to reach the intended value.

The properties use a dependency constraint to ensure both resistors
are specified together, or neither. This prevents misconfiguration
where only one resistor value is provided.

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxxxxx>
Signed-off-by: Alexis Czezar Torreno <alexisczezar.torreno@xxxxxxxxxx>
---
 .../devicetree/bindings/hwmon/pmbus/adi,max20830.yaml   | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml b/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
index f3ba6351aa5d657590d92a538910fd6b787e7a3a..3d62c03abdc30c8aada303bad263e972219b33a4 100644
--- a/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
+++ b/Documentation/devicetree/bindings/hwmon/pmbus/adi,max20830.yaml
@@ -49,11 +49,26 @@ properties:
       GPIO connected to the power-good status output pin.
     maxItems: 1
 
+  adi,vout-rfb1-ohms:
+    description:
+      Top feedback resistor (RFB1) value in ohms for VOUT sensing divider.
+      When the desired output voltage is higher than VREF, a resistor divider
+      is required. VOUT = VREF × (1 + RFB1/RFB2)
+
+  adi,vout-rfb2-ohms:
+    description:
+      Bottom feedback resistor (RFB2) value in ohms for VOUT sensing divider.
+      Datasheet recommends that RFB2 does not exceed 2.5kΩ.
+
 required:
   - compatible
   - reg
   - vddh-supply
 
+dependencies:
+  adi,vout-rfb1-ohms: ['adi,vout-rfb2-ohms']
+  adi,vout-rfb2-ohms: ['adi,vout-rfb1-ohms']
+
 unevaluatedProperties: false
 
 examples:
@@ -72,6 +87,8 @@ examples:
             ldoin-supply = <&ldoin>;
             enable-gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
             pwr-good-gpios = <&gpio 2 GPIO_ACTIVE_HIGH>;
+            adi,vout-rfb1-ohms = <10000>;
+            adi,vout-rfb2-ohms = <2000>;
         };
     };
 ...

-- 
2.34.1