[PATCH v3 2/2] irqchip/imx-irqsteer: Validate IRQ count before creating domain

[Fabio Estevam]

From: Fabio Estevam <festevam@xxxxxxxxxxxx>

The IRQ count is validated after creating the IRQ domain. If it is
invalid, probe returns without removing the domain, leaving its host
data pointing at devm-managed memory that is freed on probe failure.

Validate the count before allocating resources to avoid the leak and
dangling pointer.

Fixes: 28528fca4908 ("irqchip/imx-irqsteer: Add multi output interrupts support")
Signed-off-by: Fabio Estevam <festevam@xxxxxxxxxxxx>
---
Changes since v2:
- Newly introduced.

 drivers/irqchip/irq-imx-irqsteer.c | 7 ++-----
 1 file changed, 2 insertions(+), 5 deletions(-)

diff --git a/drivers/irqchip/irq-imx-irqsteer.c b/drivers/irqchip/irq-imx-irqsteer.c
index 653e25115083..55aec60dee40 100644
--- a/drivers/irqchip/irq-imx-irqsteer.c
+++ b/drivers/irqchip/irq-imx-irqsteer.c
@@ -217,6 +217,8 @@ static int imx_irqsteer_probe(struct platform_device *pdev)
 	 */
 	data->irq_count = DIV_ROUND_UP(irqs_num, 64);
 	data->reg_num = irqs_num / 32;
+	if (!data->irq_count || data->irq_count > CHAN_MAX_OUTPUT_INT)
+		return -EINVAL;
 
 	if (IS_ENABLED(CONFIG_PM)) {
 		data->saved_reg = devm_kzalloc(&pdev->dev,
@@ -250,11 +252,6 @@ static int imx_irqsteer_probe(struct platform_device *pdev)
 	}
 	irq_domain_set_pm_device(data->domain, &pdev->dev);
 
-	if (!data->irq_count || data->irq_count > CHAN_MAX_OUTPUT_INT) {
-		ret = -EINVAL;
-		goto out;
-	}
-
 	for (i = 0; i < data->irq_count; i++) {
 		data->irq[i] = irq_of_parse_and_map(np, i);
 		if (!data->irq[i])
-- 
2.43.0