[PATCH net-next v7 00/11] net: pcs: add basic support for RK3568 XPCS

From: Coia Prant

Date: Thu Sep 17 2026 - 17:22:10 EST


This series adds proper SGMII support for the Rockchip RK3568 SoC
using the integrated Synopsys DesignWare XPCS, along with necessary
fixes and refactoring in the stmmac core and XPCS driver.

Motivation
==========
The RK3568 integrates a DW XPCS accessed via APB3 and connected to
a Naneng Combo SerDes PHY. Several boards (e.g., Ariaboard
Photonicat) use this interface for Gigabit Ethernet. However, the
current upstream stmmac driver does not support this configuration,
and the XPCS driver has issues in SGMII poll mode that cause the
link to be reported incorrectly.

This series addresses these issues by:
- Refactoring stmmac PCS lifetime management to allow platform drivers
full control over PCS creation/destruction
- Fixing the XPCS driver's SGMII link recovery
- Adding a Rockchip XPCS platform glue driver and wiring it up in
dwmac-rk

Series overview
===============

Generic:
Patch 1: move XPCS lifetime management to platform drivers

PHY:
Patch 2: DT binding for Naneng Combo PHY SGMII MAC selection
Patch 3: implement the PHY SGMII MAC selection in driver

RK3568 XPCS/SGMII:
Patch 4: DT binding for Rockchip RK3568 XPCS
Patch 5: add XPCS and fixed-clock nodes to rk3568.dtsi
Patch 6: add ANRESTART support for SGMII link recovery
Patch 7: implement the Rockchip XPCS platform glue driver
Patch 8: DT binding for Rockchip DWMAC PCS
Patch 9: wire up SGMII support in dwmac-rk
Patch 11: update MAINTAINERS

Board enablement:
Patch 10: enable SGMII LAN port on Photonicat board

Changelog
=========

Changes since v6:

Patch 1 (net: stmmac: move XPCS lifetime management to platform drivers)
- Reworded "the created XPCS is never used" to acknowledge that
priv->hw->xpcs is still consulted by stmmac_phylink_setup() and
stmmac_init_phy() even without select_pcs()
- Added a note that the generic "pcs-handle" parsing is removed, and
that no in-tree platform relies on it

Patch 4 (dt-bindings: net: pcs: add rockchip,rk3568-xpcs support)
- Documented which patches consume the ethernet-pcs-mii@N child nodes
- Documented that phys/phy-names are provided at board level because
dtbs_check skips disabled nodes and the SerDes link is board-specific
- Documented that the CRU reset lines are intentionally left out

Patch 5 (arm64: dts: rockchip: rk3568: add XPCS and fixed-clock nodes)
- Fixed the changelog to use the actual node names (clock-xpcs-gmac0
and clock-xpcs-gmac1), and noted that clock-output-names matches the
CRU mux parent names in clk-rk3568.c
- Noted that phys/phy-names are supplied at board level

Patch 6 (net: pcs: xpcs: add ANRESTART support)
- Documented why the restart cannot go through the .pcs_an_restart op
(phylink only calls it for 802.3z, and SGMII is not one)
- Documented why the latch is cleared before issuing the restart

Patch 7 (net: pcs: xpcs: add Rockchip RK3568 platform glue driver)
- Removed the device_link_remove() calls on the failure paths:
DL_FLAG_AUTOREMOVE_CONSUMER is a managed link, and dropping it
manually triggers a WARN in device_link_put_kref()
- Updated the commit message for the Kconfig and EEE multiplier changes
- Change xpcs_rk_create() to return -EPROBE_DEFER instead of -ENOMEM
when device_link_add() fails, so the MAC probe retries if the XPCS
supplier is not bound yet

Patch 8 (dt-bindings: net: rockchip-dwmac: document pcs-handle)
- Reworded the commit message to future tense, since rk_pcs_init()
arrives in the next patch
- Gated the new required-property conditional on
rockchip,rk3568-gmac, and marked pcs-handle as invalid for the
other variants

Patch 9 (net: stmmac: dwmac-rk: add SGMII support for RK3568)
- Removed SGMII from rk_get_interfaces(): it is supplied by the XPCS's
supported_interfaces, merged by stmmac_phylink_setup()
- Added a note in the commit message explaining why the SerDes is
managed by the XPCS driver rather than through the legacy stmmac
serdes_poweron/serdes_poweroff callbacks
- Noted that PCS_XPCS is already selected by STMMAC_ETH and PM by
ARCH_ROCKCHIP

Patch 10 (arm64: dts: rockchip: rk3568-photonicat)
- Noted in the commit message that RK3568 has three Combo PHYs that
can carry SGMII, and that using combphy2 is a board-level choice

Key design decisions
====================
- The stmmac core now delegates XPCS creation entirely to platform
drivers via pcs_init/pcs_exit. This is necessary because the
generic XPCS creation logic would override any XPCS set up by the
platform driver.

- The Rockchip XPCS driver creates a virtual MDIO bus over the APB3
registers and implements address remapping. The generic XPCS core
handles all PCS configuration via phylink_pcs_ops.

- On RK3568 in SGMII mode, the MAC clock is fixed at 125 MHz and
cannot be dynamically changed. In-band mode is used, and the
generic stmmac set_clk_tx_rate callback is disabled to prevent
incorrect clock updates that would break RX.

- The SerDes and power domain are attached to the XPCS device tree
node rather than the MAC node. This reflects the actual hardware
topology and simplifies the dwmac-rk driver by keeping all PCS-related
resources self-contained. It also prepares for possible future QSGMII
support, where a single SerDes serves multiple MACs and would be
more naturally managed under the XPCS node.

Testing
=======
Board: Ariaboard Photonicat (RK3568)
OS: Armbian (trixie)
Kernel: 6.18 (backports)
Result: The SGMII interface obtains an IP address, SSH works, and
ping traffic passes without loss.

Notes
=====
- When testing out-band mode with set_clk_tx_rate, only 1000Mbps
works on both TX/RX; 10/100Mbps only works on TX side.

Dependencies
============
None. All patches apply cleanly on top of torvalds master tree (v7.3).

Acknowledgments
===============
This work was inspired by and builds upon the excellent work of others:
- Serge Semin's Synopsys DesignWare XPCS platform driver (pcs-xpcs-plat.c)
- Clément Léger's Renesas MIIC driver (pcs-rzn1-miic.c)
- The Rockchip TRM and downstream OEM drivers

Thanks in advance,
Coia Prant
---
Coia Prant (11):
net: stmmac: move XPCS lifetime management to platform drivers
dt-bindings: phy: rockchip: naneng-combphy: add rockchip,sgmii-mac-sel
property
phy: rockchip: naneng-combphy: add SGMII MAC selection for RK3568
dt-bindings: net: pcs: add rockchip,rk3568-xpcs support
arm64: dts: rockchip: rk3568: add XPCS and fixed-clock nodes
net: pcs: xpcs: add ANRESTART support for SGMII link recovery
net: pcs: xpcs: add Rockchip RK3568 platform glue driver
dt-bindings: net: rockchip-dwmac: document pcs-handle
net: stmmac: dwmac-rk: add SGMII support for RK3568
arm64: dts: rockchip: rk3568-photonicat: enable SGMII LAN port
MAINTAINERS: add entry for Rockchip XPCS driver

.../net/pcs/rockchip,rk3568-xpcs.yaml | 110 ++++
.../bindings/net/rockchip-dwmac.yaml | 18 +
.../phy/phy-rockchip-naneng-combphy.yaml | 13 +
MAINTAINERS | 9 +
.../boot/dts/rockchip/rk3568-photonicat.dts | 74 ++-
arch/arm64/boot/dts/rockchip/rk3568.dtsi | 45 ++
drivers/net/ethernet/stmicro/stmmac/Kconfig | 1 +
.../net/ethernet/stmicro/stmmac/dwmac-intel.c | 44 +-
.../stmicro/stmmac/dwmac-renesas-gbeth.c | 7 +-
.../net/ethernet/stmicro/stmmac/dwmac-rk.c | 130 +++-
.../net/ethernet/stmicro/stmmac/dwmac-rzn1.c | 7 +-
.../ethernet/stmicro/stmmac/dwmac-socfpga.c | 7 +-
.../net/ethernet/stmicro/stmmac/stmmac_mdio.c | 39 +-
drivers/net/pcs/Kconfig | 25 +
drivers/net/pcs/Makefile | 5 +-
drivers/net/pcs/pcs-xpcs-rk.c | 582 ++++++++++++++++++
drivers/net/pcs/pcs-xpcs.c | 35 +-
.../rockchip/phy-rockchip-naneng-combphy.c | 8 +
include/linux/pcs/pcs-xpcs-rk.h | 11 +
19 files changed, 1098 insertions(+), 72 deletions(-)
create mode 100644 Documentation/devicetree/bindings/net/pcs/rockchip,rk3568-xpcs.yaml
create mode 100644 drivers/net/pcs/pcs-xpcs-rk.c
create mode 100644 include/linux/pcs/pcs-xpcs-rk.h

--
2.47.3