Re: [PATCH v2 3/3] arm64: zynqmp: Add ALINX EdgeBoard FZ3A

[Michal Simek]

On 10/5/26 19:33, Pufan Jin wrote:
> Add device tree for the ALINX EdgeBoard FZ3A, a single board computer
> based on the Xilinx Zynq UltraScale+ XCZU3EG SoC.
>
> Supported peripherals:
>    - UART1 debug console
>    - eMMC (HS200) and microSD card
>    - GEM3 Ethernet with Micrel KSZ9031 PHY on the MDIO bus
>    - I2C0 and I2C1
>    - QSPI NOR flash
>    - PCIe
>    - USB 3.0 host
>    - DisplayPort output
>
> Tested on hardware with Linux 7.3.0-rc5: the board boots from SD card
> into userspace over the serial console, gem3 negotiates 1000Mbps/Full
> duplex with phy-mode = "rgmii-id", and the eMMC runs in HS200 mode.
>
> The base DTB passes CHECK_DTBS=y, and the Xilinx SoC binding passes
> dt_binding_check.
>
> Signed-off-by: Pufan Jin <2254650260@xxxxxx>
> ---
>   arch/arm64/boot/dts/xilinx/Makefile           |   1 +
>   .../xilinx/zynqmp-alinx-edgeboard-fz3a.dts    | 350 ++++++++++++++++++
>   2 files changed, 351 insertions(+)
>   create mode 100644 arch/arm64/boot/dts/xilinx/zynqmp-alinx-edgeboard-fz3a.dts
This series has no cover letter and I can't see any link to public board 
documentation. Please provide it and then I will take a look at it.
But please send proper v3.

Thanks,
Michal