Re: [PATCH v21 14/14] arm64: dts: qcom: kaanapali-mtp-camera-s5kjn5: Add DT overlay

[Hangxiang Ma]

On 10/21/2026 10:02 PM, Konrad Dybcio wrote:
> On 10/12/26 8:45 AM, Hangxiang Ma wrote:
> > Enable the S5KJN5 image sensor via CCI on Kaanapali MTP board.
> >
> > The Kaanapali MTP board connect S5KJN5 with QUP I2C bus by default. This
> > DTBO enables S5KJN5 on CCI-0 interface connected to the CSIPHY2 in four
> > lane mode on a rework camera module.
> >
> > Signed-off-by: Hangxiang Ma <hangxiang.ma@xxxxxxxxxxxxxxxx>
> > ---
>
> [...]
>
> > +&camss_csiphy2_in_port {
> > +	camss_csiphy2_inep: endpoint {
> > +		data-lanes = <1 2 3 4>;
> > +		remote-endpoint = <&csiphy2_out_ep>;
> > +	};
> > +};
>
> Please define the endpoint in the SoC DTSI like the glymur submission:
>
> https://lore.kernel.org/linux-arm-msm/b5734dac-1285-452b-8107-9164e6a3e5fa@xxxxxxxxxxxxxxxx/T/#m55a2d04f3fe573dbbc86fe89a874514494eca345
>
> [...]
>
>
> > +&csiphy2_in_port {
> > +	csiphy2_in_ep: endpoint {
> > +		bus-type = <MEDIA_BUS_TYPE_CSI2_DPHY>;
> > +		clock-lanes = <0>;
> > +		data-lanes = <1 2 3 4>;
> > +		remote-endpoint = <&s5kjn5_out_ep>;
> > +	};
> > +};
> > +
> > +&csiphy2_out_port {
> > +	csiphy2_out_ep: endpoint {
> > +		remote-endpoint = <&camss_csiphy2_inep>;
> > +	};
> > +};
>
> likewise for these two
>
> With that:
>
> Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>
>
> Konrad

Ack

---
Best Regards,
Hangxiang