Re: [PATCH v2 4/6] arm64: dts: qcom: glymur-crd: Add PM8010 camera PMIC

[Jishnu Prakash]

Hi Konrad,

On 10/19/2026 5:38 PM, Konrad Dybcio wrote:
> On 10/15/26 12:52 PM, Nihal Kumar Gupta wrote:
>> From: Jishnu Prakash <jishnu.prakash@xxxxxxxxxxxxxxxx>
>>
>> Add the PM8010 PMIC node with seven LDO regulators and pinctrl
>> configuration for reset pin. The LDOs are needed to power the
>> camera sensors and associated hardware.
> 
> [...]
> 
>> +	pm8010: pmic@8 {
>> +		compatible = "qcom,pm8010-i2c";
>> +		reg = <0x8>;
>> +
>> +		reset-gpios = <&tlmm 106 GPIO_ACTIVE_LOW>;
>> +
>> +		vdd-l1-l2-supply = <&vreg_l6p>;
>> +		vdd-l3-l4-supply = <&vreg_bob1_e0>;
>> +		vdd-l5-supply = <&vreg_bob1_e0>;
>> +		vdd-l6-supply = <&vreg_bob1_e0>;
>> +		vdd-l7-supply = <&vreg_bob1_e0>;
>> +
>> +		pinctrl-names = "default";
>> +		pinctrl-0 = <&pm8010_default>;
> 
> property-n
> property-names
> 
> in this order, please
> 
> [...]
> 
>> +		regulators {
>> +			vreg_l1p: ldo1 {
>> +				regulator-name = "vreg_l1p";
>> +				regulator-min-microvolt = <1200000>;
>> +				regulator-max-microvolt = <1200000>;
>> +			};
> 
> Shouldn't this be 1.104 V?

Yes, you're right, I checked again and I see L1P and L2P should
both be updated to this.

I'll address this and your other comments in the next patch version.

Thanks,
Jishnu

> 
> 
> [...]
>  > +	pm8010_default: pm8010-default-state {
>> +		reset-n-pins {
> 
> Drop this inner node and put the properties directly under pm8010_default
> 
> Konrad
> 
>> +			pins = "gpio106";
>> +			function = "gpio";
>> +			drive-strength = <2>;
>> +			bias-disable;
>> +		};
>> +	};
>> +
>>  	sdc2_card_det_n: sd-card-det-n-state {
>>  		pins = "gpio221";
>>  		function = "gpio";
>>