Re: [PATCH 3/3] hwmon: (asus-ec-sensors) add water temperatures for MAXIMUS IX EXTREME

[Guenter Roeck]

On Mon, Oct 26, 2026 at 09:57:37AM +0100, Remy Demangeot wrote:
> From: Remy Demangeot <remy@xxxxxxxxxxxxx>
> 
> The MAXIMUS IX EXTREME has a second EC (firmware ID "RGE2-Z270-0109"),
> not handled by the ACPI EC driver, at I/O ports 0x68 (data) and 0x6c
> (command/status). It uses the standard EC protocol (0x80 read, 0x81
> write) and the same bank register (0xff). Its bank 1 holds the water
> temperatures: WATER_IN 0x0d, WATER_OUT 0x0b, WATER_IN2 0x13 and
> WATER_OUT2 0x11, as signed degrees Celsius with -60 for an absent
> probe. Water_In and Water_Out are at the same offsets as on the AMD
> 400-series boards.
> 
> Describe registers of the second EC by setting ASUS_EC2_BANK_FLAG in
> the sensor bank. Banks are sorted, so such registers are read last;
> the second EC bank is saved and restored like the first one, under the
> same hardware access mutex. The I/O ports are only requested for
> boards using these sensors.
> 
> Add Water_In 2 and Water_Out 2 sensors and enable the four water
> temperatures for the board. Readings match HWiNFO 8.54 on the same
> machine.
> 
> Signed-off-by: Remy Demangeot <remy@xxxxxxxxxxxxx>

Applied.

Thanks,
Guenter