[PATCH V2 1/2] ARM: dts: imx6ull-dhcor-maveo-box: Remove unused SPI device

[Christoph Niedermaier]

On the maveo box, the SPI pins are connected to connector X10,
but no device is connected. The device "dhcom-board" was used
only to test the hardware, but was not removed afterward. So
remove this device to accurately represent the current hardware
configuration here. Also remove the okay status, since there
are no longer any devices defined in the interface.

Fixes: 145e2732a5e9 ("ARM: dts: imx6ull-dhcor: Add Marantec maveo box")
Signed-off-by: Christoph Niedermaier <cniedermaier@xxxxxxxxxxxxxxxxxx>
---
Cc: Rob Herring <robh@xxxxxxxxxx>
Cc: Krzysztof Kozlowski <krzk+dt@xxxxxxxxxx>
Cc: Conor Dooley <conor+dt@xxxxxxxxxx>
Cc: Frank Li <Frank.Li@xxxxxxx>
Cc: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
Cc: Pengutronix Kernel Team <kernel@xxxxxxxxxxxxxx>
Cc: Fabio Estevam <festevam@xxxxxxxxx>
Cc: Marek Vasut <marex@xxxxxxxxxxxx>
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: imx@xxxxxxxxxxxxxxx
Cc: kernel@xxxxxxxxxxxxxxxxxx
Cc: linux-kernel@xxxxxxxxxxxxxxx
---
V2: - Remove also okay status
---
 arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts
index 047f7b2d8526..0b48de79c595 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts
+++ b/arch/arm/boot/dts/nxp/imx/imx6ull-dhcor-maveo-box.dts
@@ -59,15 +59,6 @@ &ecspi4 {
 	cs-gpios = <&gpio2 15 GPIO_ACTIVE_LOW>;
 	pinctrl-0 = <&pinctrl_ecspi4>;
 	pinctrl-names = "default";
-	status = "okay";
-
-	spidev@0 {
-		compatible = "dh,dhcom-board";
-		reg = <0>;
-		spi-cpha;
-		spi-cpol;
-		spi-max-frequency = <54000000>;
-	};
 };
 
 &gpio1 {
-- 
2.30.2