[PATCH v5 0/3] phy: cix: Add Sky1 DisplayPort PHY
From: Luo Liu
Date: Mon Nov 16 2026 - 02:38:14 EST
Add the CIX Sky1 dedicated DisplayPort PHY: the binding, the driver,
and the Sky1 devicetree node.
Changes in v5:
The binding and the devicetree node are unchanged. The driver changes
address review comments:
- Drop .reset. phy_reset() pulses the block reset and does not rerun
phy_init(), so the CDB and PMA programming stay cleared and a later
configure or power-on can time out. phy_init() already pulses the
reset before loading those registers. The DP controller pairs
phy_init() and phy_exit().
- Rename is_edp to external_dp. The flag selects the higher swing
table for an external connector. It is not Embedded DisplayPort.
- Call writel() directly. cix_dp_phy_write() only forwarded the write.
- Roll back a PLL enable that fails after the PLL reset is released.
The original error is returned if the rollback itself fails.
- Drop the powered flag. A failed rate update left the PLL disabled
while the flag stayed set. Every rate change now disables the PLL,
programs the new dividers, and enables the PLL again.
Luo Liu (3):
dt-bindings: phy: Add CIX Sky1 DP PHY
phy: cix: Add Sky1 DP PHY driver
arm64: dts: cix: Add Sky1 DP PHY node
.../bindings/phy/cix,sky1-dp-phy.yaml | 67 ++
MAINTAINERS | 8 +
arch/arm64/boot/dts/cix/sky1-orion-o6.dts | 4 +
arch/arm64/boot/dts/cix/sky1.dtsi | 10 +
drivers/phy/Kconfig | 1 +
drivers/phy/Makefile | 1 +
drivers/phy/cix/Kconfig | 18 +
drivers/phy/cix/Makefile | 2 +
drivers/phy/cix/phy-cix-dp.c | 993 ++++++++++++++++++
9 files changed, 1104 insertions(+)
create mode 100644 Documentation/devicetree/bindings/phy/cix,sky1-dp-phy.yaml
create mode 100644 drivers/phy/cix/Kconfig
create mode 100644 drivers/phy/cix/Makefile
create mode 100644 drivers/phy/cix/phy-cix-dp.c
base-commit: 6628e7d4c6b25c8d18f1345e3a20d21829aae7e4
--
2.25.1