Re: [RFC PATCH v2 5/9] fs/resctrl: Allow mba_MBps with assignable MBM counters
From: Ben Horgan
Date: Tue Nov 17 2026 - 06:38:08 EST
Hi Jinjie,
On 12/11/2026 13:12, Jinjie Ruan wrote:
> The controller needs a counter for the event selected by mba_MBps_event
> in every monitoring group, so mba_MBps is refused when MBM counters are
> assignable. On MPAM a group's monitor is assigned from a fixed pool
> when the group is created, and users can otherwise only pick a
> percentage of a maximum that firmware does not report.
>
> Allow the controller when the architecture has a fixed assignment mode
> and assigns counters when a group is created. Keep mbm_assign_on_mkdir
> enabled while the controller is in use, restore its previous value
> when the controller is disabled, and refuse to unassign the
> controller's counter meanwhile.
I'm afraid there has been some miscommunication here. What I was trying
to suggest is that MPAM could when using the software controller use the
default mbm_assign_mode as is used in intel systems. All the counters
are allocated up front and there is one of each supported type per
monitor group. Using mbm_assign_on_mkdir doesn't always give you
guaranteed assigned counters as you point out in your
patch "arm_mpam: resctrl: Use the domain's counter ID". I haven't
thought through all the abi consideration but it seems plausible, what
do you think?
Thanks,
Ben
>
> Only MPAM has this mode; other systems keep the previous behavior.
>
> Suggested-by: Ben Horgan <ben.horgan@xxxxxxx>
> Signed-off-by: Jinjie Ruan <ruanjinjie@xxxxxxxxxx>
> ---
> Documentation/filesystems/resctrl.rst | 7 +++++--
> fs/resctrl/monitor.c | 25 ++++++++++++++++++++++
> fs/resctrl/rdtgroup.c | 30 +++++++++++++++++++++------
> 3 files changed, 54 insertions(+), 8 deletions(-)
>
> diff --git a/Documentation/filesystems/resctrl.rst b/Documentation/filesystems/resctrl.rst
> index b52795e03303..d70aec6f7096 100644
> --- a/Documentation/filesystems/resctrl.rst
> +++ b/Documentation/filesystems/resctrl.rst
> @@ -471,7 +471,8 @@ with the following files:
> Determines if a counter will automatically be assigned to an RMID, MBM event
> pair when its associated monitor group is created via mkdir. Enabled by default
> on boot, also when switched from "default" mode to "mbm_event" counter assignment
> - mode. Users can disable this capability by writing to the interface.
> + mode. Users can disable this capability by writing to the interface. While the
> + MBA software controller is enabled, auto assignment cannot be disabled.
>
> "0":
> Auto assignment is disabled.
> @@ -704,7 +705,9 @@ When monitoring is enabled all MON groups may also contain:
> mbm_total_bytes:0=e;1=e
> mbm_local_bytes:0=e;1=e
>
> - Assignments can be modified by writing to the interface.
> + Assignments can be modified by writing to the interface. While the
> + MBA software controller is enabled, the counter of the event the
> + controller uses cannot be unassigned.
>
> Examples:
>
> diff --git a/fs/resctrl/monitor.c b/fs/resctrl/monitor.c
> index 8f3b8c3e3010..5a67c8089615 100644
> --- a/fs/resctrl/monitor.c
> +++ b/fs/resctrl/monitor.c
> @@ -1210,6 +1210,12 @@ ssize_t resctrl_mbm_assign_on_mkdir_write(struct kernfs_open_file *of, char *buf
> goto out_unlock;
> }
>
> + if (!value && is_mba_sc(NULL)) {
> + rdt_last_cmd_puts("mbm_assign_on_mkdir is required by the software controller\n");
> + ret = -EBUSY;
> + goto out_unlock;
> + }
> +
> r->mon.mbm_assign_on_mkdir = value;
>
> out_unlock:
> @@ -1776,6 +1782,19 @@ static struct mon_evt *mbm_get_mon_event_by_name(struct rdt_resource *r, char *n
> return NULL;
> }
>
> +/*
> + * Return the event the MBA software controller uses as its input for @rdtgrp.
> + * A monitor group has no event of its own: its bandwidth is summed into the
> + * parent control group, which is the group with the mba_MBps_event setting.
> + */
> +static enum resctrl_event_id rdtgrp_mba_mbps_event(struct rdtgroup *rdtgrp)
> +{
> + if (rdtgrp->type == RDTMON_GROUP)
> + return rdtgrp->mon.parent->mba_mbps_event;
> +
> + return rdtgrp->mba_mbps_event;
> +}
> +
> static int rdtgroup_modify_assign_state(char *assign, struct rdt_l3_mon_domain *d,
> struct rdtgroup *rdtgrp, struct mon_evt *mevt)
> {
> @@ -1789,6 +1808,12 @@ static int rdtgroup_modify_assign_state(char *assign, struct rdt_l3_mon_domain *
> ret = rdtgroup_assign_cntr_event(d, rdtgrp, mevt);
> break;
> case '_':
> + if (is_mba_sc(NULL) &&
> + mevt->evtid == rdtgrp_mba_mbps_event(rdtgrp)) {
> + rdt_last_cmd_puts("Counter is in use by the software controller\n");
> + ret = -EBUSY;
> + break;
> + }
> rdtgroup_unassign_cntr_event(d, rdtgrp, mevt);
> break;
> default:
> diff --git a/fs/resctrl/rdtgroup.c b/fs/resctrl/rdtgroup.c
> index b32831871f70..518d89b0c67d 100644
> --- a/fs/resctrl/rdtgroup.c
> +++ b/fs/resctrl/rdtgroup.c
> @@ -2610,10 +2610,9 @@ static void mba_sc_domain_destroy(struct rdt_resource *r,
> * The MBA software controller is supported only if MBM is supported and MBA is
> * in linear scale, and the MBM monitor scope is the same as MBA control scope.
> *
> - * The software controller cannot be supported when the MBM counters are
> - * assignable. There is no guarantee that MBM counters are assigned to the
> - * event backing the software controller in all monitoring domains of all
> - * monitoring groups.
> + * The controller needs a counter for its event in every monitoring group.
> + * With assignable counters that requires a fixed assignment mode, with
> + * counters assigned automatically while the controller is in use.
> */
> static bool supports_mba_mbps(void)
> {
> @@ -2623,9 +2622,13 @@ static bool supports_mba_mbps(void)
> return (resctrl_is_mbm_enabled() &&
> r->alloc_capable && is_mba_linear() &&
> r->ctrl_scope == rmbm->mon_scope &&
> - !rmbm->mon.mbm_cntr_assignable);
> + (!rmbm->mon.mbm_cntr_assignable ||
> + rmbm->mon.mbm_cntr_assign_fixed));
> }
>
> +/* mbm_assign_on_mkdir before the software controller forced it on. */
> +static bool mba_sc_saved_assign_on_mkdir;
> +
> /*
> * Enable or disable the MBA software controller
> * which helps user specify bandwidth in MBps.
> @@ -2633,6 +2636,7 @@ static bool supports_mba_mbps(void)
> static int set_mba_sc(bool mba_sc)
> {
> struct rdt_resource *r = resctrl_arch_get_resource(RDT_RESOURCE_MBA);
> + struct rdt_resource *rmbm = resctrl_arch_get_resource(RDT_RESOURCE_L3);
> u32 num_closid = resctrl_arch_get_num_closid(r);
> struct rdt_ctrl_domain *d;
> unsigned long fflags;
> @@ -2643,6 +2647,20 @@ static int set_mba_sc(bool mba_sc)
>
> r->membw.mba_sc = mba_sc;
>
> + /*
> + * The controller needs its event counted in every monitoring group:
> + * force automatic assignment on, and restore the user's setting when
> + * the controller is disabled.
> + */
> + if (rmbm->mon.mbm_cntr_assignable) {
> + if (mba_sc) {
> + mba_sc_saved_assign_on_mkdir = rmbm->mon.mbm_assign_on_mkdir;
> + rmbm->mon.mbm_assign_on_mkdir = true;
> + } else {
> + rmbm->mon.mbm_assign_on_mkdir = mba_sc_saved_assign_on_mkdir;
> + }
> + }
> +
> rdtgroup_default.mba_mbps_event = mba_mbps_default_event;
>
> list_for_each_entry_rcu(d, &r->ctrl_domains, hdr.list, lockdep_is_cpus_held()) {
> @@ -3352,7 +3370,7 @@ static int rdt_parse_param(struct fs_context *fc, struct fs_parameter *param)
> ctx->enable_cdpl2 = true;
> return 0;
> case Opt_mba_mbps:
> - msg = "mba_MBps requires MBM (mbm_event mode not supported) and linear scale MBA at L3 scope";
> + msg = "mba_MBps requires MBM and linear scale MBA at L3 scope";
> if (!supports_mba_mbps())
> return invalfc(fc, msg);
> ctx->enable_mba_mbps = true;