Re: [PATCH] wifi: brcmfmac: disable TX beamforming on BCM4364

From: Aditya Garg

Date: Tue Nov 17 2026 - 12:51:23 EST




> On 17 Nov 2026, at 2:07 AM, Arend van Spriel <arend.vanspriel@xxxxxxxxxxxx> wrote:
>
> On Wed, 4 Nov 2026 16:16:23 +0100, Andre Eikmeyer <dev@deq.rocks> wrote:
>> With "txbf" enabled, the BCM4364 firmware (9.30.514.0.32.5.94, as shipped
>> by Apple for the MacBookPro15,1) transmits a single beamformed spatial
>> stream (nrate VHT MCS9 NSS1 TXBF) towards a two stream AP. With "txbf"
>> cleared it picks two streams (VHT MCS9 NSS2) on its own. The firmware
>> enables "txbf" by default, so the driver has to clear it.
>>
>> [...]
>>
>> Tested-by: Yossef Osman <Yossef.Osman@xxxxxxxxx>
>> Tested-by: Aditya Garg <aditya.garg@xxxxxxxxx>
>> Signed-off-by: Andre Eikmeyer <dev@deq.rocks>
>
> [...]
>
>> @@ -450,8 +451,12 @@ int brcmf_c_preinit_dcmds(struct brcmf_if *ifp)
>> goto done;
>> }
>>
>> - /* Enable tx beamforming, errors can be ignored (not supported) */
>> - (void)brcmf_fil_iovar_int_set(ifp, "txbf", 1);
>> + /* Enable tx beamforming, errors can be ignored (not supported).
>> + * BCM4364 firmware enables it by default and then transmits a single
>> + * beamformed stream instead of two, halving its uplink throughput.
>> + */
>> + (void)brcmf_fil_iovar_int_set(ifp, "txbf",
>> + drvr->bus_if->chip != BRCM_CC_4364_CHIP_ID);
>> done:
>> return err;
>> }
>
> The chip ID check has the same problem as in the ARP/ND offload patch [1]:
> the issue is described as specific to the firmware shipped by Apple
> (9.30.514.0.32.5.94), but the quirk applies to every BCM4364. Please
> restrict it as suggested there.
>
> Also, the comment says "Enable tx beamforming" while the code now
> conditionally disables it. Please make the code self-explanatory, e.g. a
> local variable or an explicit if (chip == BRCM_CC_4364_CHIP_ID) with the
> txbf value spelled out, instead of passing a bool expression as the
> iovar value.
>
> Minor: typo "refression" in the commit message, and the subject lacks
> the target tree (wireless-next) which wifibot flagged.
>
> Since this is a throughput quirk (not a fix) I would also like to know
> whether TX beamforming is functional at all on the BCM4364 or just
> mis-selected by rate control, so the commit message can state the actual
> root cause.

Unrelated but Airdrop conversation seems to have been stalled :(.